Question about Sharp Projection Televisions

1 Answer

I get white dots upper left corner across the screen of set now I have a Sharp LC-37D40U LCD TV. Is it the pixels?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 63 Answers

Hi Yabby,

If the dots are very narrow and jump about and you're receiving an analogue signal it could be teletext information. This is normal but is usually hidden off the top of the screen. You need to adjust the picture height to take them off the top.

Regards

Andy

Posted on Jun 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix my 65" toshiba white pixel problem


Thats caused by the DLP chip. Unfortunately most Toshiba models will end up having to have both the DLP chip and the formatter board replaced at the same time to fix the issue where as other models only require replacing the DLP chip alone to fix the white dots issue

Apr 06, 2013 | Toshiba 65HM167 65" Projection Television

1 Answer

Power and OPC blinks, TV will not change Input modes


Try removing set and or a box if used from power for several minutes.

Dec 23, 2012 | Sharp LC-46SB54U LCD TV 46 inch Class,...

1 Answer

Pinhole om rear projection Mitsibishi TV


not an actual hole I PRESUME but a white dot which can be seen in the picture? That if a dot is a bad pixel in the optical light engine.

Jun 11, 2012 | Projection Televisions

2 Answers

It has blue spots (pixels) around the edges. There is a egg shaped center that does not have it, all other places do. It stays on the entire time, even after turning off the TV, until the lamp goes off....


Hello
This is really a problem to some Mitsubishi projection TVs.

This LCD Projection Television uses three LCD panels to create the screen image. This technology creates the image using small dots, or picture

elements (pixels). Your LCD Projection TV is manufactured to a high level of performance and quality, in fact, 99.99% perfect in the number of

properly functioning pixels. As in other display technology, sometimes a pixel is continuously active, inactive or the incorrect color. Our standard is
clear; MDEA warrants only that the percentage of properly functioning pixels will be not less than 99.99% of all pixels.
This is the company says about this problem. Your set need service care fro authorised service center.

BEFORE REQUESTING SERVICE, please review the instruction booklet to insure proper installation and correct customer control
adjustment. If the problem persists please arrange for warranty service

Sep 29, 2011 | Mitsubishi WD52527 52" Projection HDTV

1 Answer

The lower left hand corner of the screen is turning blue


catually is problum is related with blue lcd & blue polizer but first you clean the optical unit if the problum gon then ok other wise must chang blue lcd & blue polorize with uv filter plese contect to your nearst sony service centre

Feb 05, 2010 | Sony Grand WEGA KDF-60WF655 60" Rear...

1 Answer

OUR 52" rear projection tv is now unwatchable because of white pixels everywhere on the screen. Started with a few now thousands


it sounds like a lot of dust in the light engine lens.usually pixel defects are purple or black...question is your set a lcd or a dlp format? and how large are the dots. if real tiny it will be dust. if large it will be insects... have a qualified serviceman take a look.. good luck...

Nov 13, 2009 | Samsung HL-S5086W 50" HDTV

1 Answer

White pixels cover half of the bottom part of the screen


You probably have faulty lcd panels inside the tv. replacing them can cost alot of money. I assume you have tried different inputs? If the dots are in excactly the same place then the lcd panels or lcd controller are faulty.

Jun 16, 2009 | Samsung Projection Televisions

1 Answer

RE: Sharp Aquos LCD TV, MODEL LC-37D40U Tried to switch the TV on via remote, and I hear the TV turning on, but then it automatically turns itself off again. Tried it several different ways using...


A component is shorting out, and the TV is auto turning itself off for protection. Usually it is a shorted out horizontal output transistor. Only a tech can fix this.

Nov 13, 2008 | Sharp Projection Televisions

4 Answers

Little white dots on the screen


dirty lens, dirty mirrors, warped light guides, spider webs and mini-UFOs that fly across the inside can cause what you described.

but 6 months is pretty early for a cleaning but possible.

May 16, 2008 | Mitsubishi WD-62725 62" Rear Projection...

1 Answer

My 42 aquos lc-42d62u is just over 3 months old.Last week the screen had many white dots appear but they went away the next day.Now I have blueish lines moving across my screen.They have been on all day...


With a new unit like this call Sharp at 1-800 BE SHARP and they wil refer you to an authorized service center to get this resolved under warranty.

Apr 13, 2008 | Projection Televisions

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sharp Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...