Question about Mirra M-120 (MIRRAPERSONALSERVERM120)

4 Answers

M120 will not power up - no lights, nothing

Following a vacation break during which the Mirra was powered down, and a UPS glitch during subsequent power up, my M120 is now completely dead. Suspecting a PSU problem rather than anything more drastic, I am wondering who might be able to diagnose/repair it without data loss.

Posted by on

Ad

4 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 260 Answers

If your unit is completely dead it was most likely hit by a power surge during your trip (if it was plugged in). It can still have contained damage. You will not lose data if you remove the left panel and take a look at the power supply where the cord enters the machine). You may have to replace the power supply.
Of course, before repair, check to make sure you outlet is working properly.

Posted on Jun 26, 2008

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 3,422 Answers

Hi,

Yes this is a PSU issue and requires a physical presence of a tech to fix this.

Posted on Jun 26, 2008

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 1,894 Answers

Does the UPS start?

if it starts the problem can be inside cabinet .. mostly smps

Posted on Jun 26, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,028 Answers

The Geek Squad at Bestbuy can do this. They are rather pricy though.

Posted on Jun 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my APC BR500c ups makes continuous ticking noise when i switch on after a short break in use ?


Are you getting any warning lights? Your post seems to state that this unit is not very old? If still under warranty contact APC, they have fantastic customer service.

Jun 19, 2015 | APC Computers & Internet

1 Answer

I use a Belkin Surge Protector UPS 600VA, and run Win 7 64 bits. In "System Configuration", "Services" tab, Belkin APmonitor is stopped, and Belkin APMRMI is running. Nothing shows on...


2 scenarios will either play out at the end of the day:
1. During power outage, your UPS will continue to supply backup power for the number of minutes.it is built/designed to do for your PC after which it shuts down and your PC due to lack of power shuts down too.
2. if you've programmed your PC to shut down after say a short period it idles, your PC will shut down even though your UPS is still fully operational.

A third approach is to sync the situation/scenario you envisage by powering off your UPS power supply at the mains/wall receptacle.

Watch what happens next by leaving your PC idle but still connected to the UPS still powered on (but without the mains power supply to it)

Oct 06, 2017 | Computers & Internet

1 Answer

Power glitched and the wii won't come back on. changed the battery. still nothing


Is it completely dead???, no sound, no lights??? if it's the case, try unplugging it for several hours, than try again, if it still not working than claiming a new one from your insurance company and buy a UPS, connect it to the UPS (Uninterrupted Power Supply) IN THE OUTLET MARKED WITH A BATTERY ICON, this will prevent this in the future...

Good Luck!!!

Mar 17, 2011 | Computers & Internet

1 Answer

My UPS does not start


I'm guessing that during the power outage, the ups battery completely discharged. Now it will take about 14-15hrs to recharge it.It will not support any devices until it is fully charged. Remove all load devices and let the battery restore to full charge before re-connecting the devices. If the battery does not recover, it needs to be replaced.

Apr 16, 2010 | APC MasterSwitch Power Receptacle - Power...

1 Answer

Ups troubles


What is happening here is you are transferring load to battery during a power outage but on return of Line Power the UPS is not smoothly transferring back to Normal mode. As a result you are basically turning off your computer. Two options... shut down your computer orderly during an outage or buy a new UPS.

DD
Dynamic Power Solutions LLC

Aug 20, 2008 | Computers & Internet

Not finding what you are looking for?
Mirra M-120 (MIRRAPERSONALSERVERM120) Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mirra Computers & Internet Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

kakima

Level 3 Expert

102366 Answers

David Payne
David Payne

Level 3 Expert

14162 Answers

Are you a Mirra Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...