Question about Kenwood Excelon KAC-X811D Car Audio Amplifier

2 Answers

Pioneer Car Stereo blows fuses

I have a Pioneer car stereo that keeps blowing the fuse that controls the right rear speaker. Also, when I turn my vehicle to the right, the entire radio goes out, then comes back on. Can you help me?

Posted by on

  • doctorj212 Jan 14, 2009

    i have a similar problem, except the fuse that keeps blowing out is in my amp/sub. ive taken my deck back apart and now need further explenation.

    thank you

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

You have a short on the right side of the vehicle, you mention a fuse to the right channel speaker keeps blowing which tells me that either the speaker is blown or the wire running to it from the deck is touching metal somewhere. Check the wiring, or install a different speaker and see if it takes care of the problem. When you turn right the system goes off then back on tells me that there's a short. Check all of your stereo related wiring.

Posted on Jul 17, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

I also have this problem also so i took it apart with my dads mig welder and smeared peanut butter and bacon grease all over my mother board and it didnt work so scratch that idea then i connected my ground to my battery cable and that seemed to do the trick a couple days then it started again so i put a 0 gage wiring harness and it helped and my dad a reeetard and that he hates me .

Posted on Aug 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My kenwood ka-87 stereo integrated amplifier keeps blowing fuses any idea why?


First I would disconnect the speakers and then power up and see if it blows if not add a speaker at a time and make sure the speaker is not grounding on metal

Jun 25, 2016 | Kenwood Car Amplifiers

1 Answer

What causes the fuses in my TA-AV621 integrated stereo amplifier to keep blowing right when I hit the power button


They are receiving too much power causing them to blow get a bigger fuse but be careful that will allow more power to go through

Jul 01, 2015 | Car Amplifiers

1 Answer

How do I reset my pioneer deh-x6500bt car stereo and produce sound from my rear speakers?


a 'reset' of the entire stereo should be able to be accomplished by disconnecting the battery for several minutes: alternately if you remove the faceplate there should be a reset button you would need a pen to press, however you should be able to find the EQ levels and set the balance and fade I think it is so the rear produces sound, if that is not the case, I would check wiring to make sure nothing is loose. I suppose it could only be a software/firmware problem with the stereo itself however, if you have had this happen before and it was fixed without tinkering with the wiring.

Jul 30, 2014 | Pioneer DEH-X6500BT MP3/USB A2DP Bluetooth...

1 Answer

Car audio amplifer blowing fuses


why are you in stereo for subs? mono all the way.

Feb 21, 2010 | Kenwood KAC-7252 Car Audio Amplifier

2 Answers

What do you do when your amp keeps blowing fuses


First off which fuse is it? The inline fuse from the battery or the amplifiers power supply fuse? Blowing the main fuse from the battery is caused by either the load (your amp) drawing too much current or you have a short to ground somewhere. Maybe there is a tear in the 12Vdc line and it is shorting to the chassis of your car. If the amps power supply fuse is blowing as soon as it turns on your amp has a shorted power supply. This will require internal component changes by a technician. If it is blowing after operation at high volumes I would say change the impedance that the amp is driving. If you are at 2 ohm try to rewire your speakers for four ohm. (go from parallel to series wiring then bridge mono or operate the amp in stereo mode)

Feb 07, 2010 | Infinity Reference 1300a Car Audio...

1 Answer

I have a kenwood kac-7202 and it keeps blowing the in-line fuse


Are all the wires hooked in right? On the bare parts of the wires, are there any 2 wires touching? Most importantly, do you have the correct fuse for the stereo?

Oct 11, 2009 | Kenwood KAC-7202 Car Audio Amplifier

2 Answers

Sony XM1002HX keeps blowing fuse


AUDIO OUTPUT TRANSISTOR OR IC IS SHORTED

Aug 24, 2009 | Sony Car Amplifiers

1 Answer

Keep blowing fuses


Check for shorts to ground in the speaker wiring, the speakers themselves, total Impedance, especially woofers. Proper size power and ground wire and all connections. Use a Ohmmeter or find a friend with one that knows how to use it, If all else fails RMA .
Good luck, sumthin

Jun 10, 2008 | Kenwood KAC-7202 Car Audio Amplifier

1 Answer

Amp blowing fuses


The amplifier probably has shorted output transistors.

Disconnect the speakers and RCA cables. Replace the fuses with two 10 amp fuses or a single 20 amp fuse. If the amp blows the fuse when it powers up, the outputs are almost certainly the problem. Don't try it with the two 30 amp fuses. The smaller fuses will provide more protection for the power supply. If the amp powers up with the smaller fuses and they don't blow, check the speakers and the wiring (for shorts to ground or shorts between wires).

Nov 22, 2007 | Rockford Fosgate p-450.4 Car Audio...

2 Answers

Kenwood 7202 Amp that is blowing fuses


If your speakers are wired for an impedance below 4 ohms mono or 2 ohms stereo, that would make it shut off. If you have a speaker wire shorted to ground, it would also cause the amp to go into protection.

 

If the speakers are not the problem, it may be shutting down because the voltage at the amp is dropping too low.

 

Oct 19, 2007 | Kenwood KAC-7202 Car Audio Amplifier

Not finding what you are looking for?
Kenwood Excelon KAC-X811D Car Audio Amplifier Logo

651 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenwood Car Amplifiers Experts

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Pieter Vleeshouwers

Level 3 Expert

1423 Answers

Are you a Kenwood Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...