Question about Televison & Video

1 Answer

When i sometimes put my telly on the picture fails to come on but the sound is fine.other times it comes on but about 20 mins later the screen will go blank

Posted by on

  • worthings Jun 26, 2008

    lcd 32c3030 toshiba regza

  • Andrew Real May 11, 2010

    What type of display does the set have? Plasma, LCD or CRT(tube).

    Do you have a model number?

    It sounds like it could be a LCD set with the inverter playing up, we get alot of these.

    Regards

    Andy


×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 63 Answers

It does sound like it could be the inverter, but its very rare in Toshiba sets compared to other brands.

Can you see a very faint picture?

The inverter supplies voltages to the back light which is a bit like a flourescent tube behind the screen that makes to screen light up.

Here is somewhere you can buy the inverter but it might be better to take it to a qualified technician as there are dangerous voltages inside TV's. Note that from a technician the part is likely to cost more than this supplier as this is where the techs get them from and they have to put thier margin on it to make a living and cover thier costs.

Hope this helps

Andy

Posted on Jun 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

KDF60XF955 LCD Projection TV


No you didn't but sometimes when lamp goes out there is a fuse also goes with it. If the new worked for a short time or never worked then I woul look for an open fuse. I would need schematic to find. Are you can keep asking here until someone give more helpful info.

Jan 04, 2008 | Televison & Video

2 Answers

Tv restarts while we're watching it


Hi,
It sounds lamp is weak in tv and need to be replaced.
If lamp has not been replaced in last 2-3 years then replace it to get tv problem fixed.
Thanks.

Jun 07, 2010 | Sony KDS-R60XBR1 60" Projection HDTV

2 Answers

Sony kf 50e200a screen goes black and sound turns off for min...


TV has gone into "protect mode" to do just that to protect against the damaging failure that has been detected, you will need a servicer to diagnose the failure. Good luck and Merry Christmas!

Dec 25, 2009 | Televison & Video

1 Answer

Mitsubishi VS-50707 screen is jittery when it first turns on


Sounds like the verticle circuit is failing a honest shop will take of this for you around 180-230 if you want to do yourself youll need a iron and some filters and an verticle ic

Sep 26, 2009 | Mitsubishi VS-50707 50" Rear Projection...

1 Answer

NO PICTURE


it is you senser that when you take the back end of your cover off there is a little chip there just tape it lol

Apr 18, 2008 | RCA HDLP50W151 50" Rear Projection HDTV

1 Answer

Mitsubishi WT-46807 46 in picture bends and the blue red and white all seperates


intermittent convergence fail. suggest re-soldering the 2 convergence output ICs on the middle power board. they are the 2 large devices located on the largest heat-sink on the middle board(looking at from back) once you re-solder them as long as the aren't faulty internally you should be all set.

Mar 28, 2008 | Mitsubishi WT-46807 46" Rear Projection...

1 Answer

Screen went blurry 20 minutes later no picture no sound just red flashing light on front


These sets had bad welds in the gun assemblies of the picture tubes. Now, one of the tubes has failed (shorted) and the cost would be too high to replace all three.

Mar 02, 2008 | Sony KP-51WS510 51" Rear Projection...

4 Answers

Cleaning rear projection screen


I read in the manual for the Sony KDF 50E3000 that you should use warm soapy water on a clean cloth if you aren't able to remove it with a dry cloth. I find that the microfiber cloths work best.

Feb 11, 2008 | Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69718 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6364 Answers

yadayada
yadayada

Level 3 Expert

63456 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...