Question about Kenmore AC2044-1 Air Purifier

1 Answer

Clean air cell light

Our machine shuts off and light comes on saying clean air cell. this was done and machine still say same and wont run. what can i do?

Posted by on

  • samoan79 Jul 18, 2008

    my cleaner also cuts off after about 15 minutes indicating a need to clean the filter but it is already clean. help!

  • Anonymous Apr 27, 2009

    what is a cell and how do i make the cell light go off

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinking 'Check Collector Cell' light


which model XL series do you have? There is obviously something shorted or arcing on the plates of the cell. look at the plates and see if they are laying flat and the wires are all still attached across the front of the cell. A loose, sagging, broken or bad contact on the end plates will cause the bad cell lights. clean off the area where the cell makes contact inside the unit. The metal strips that run across the ends of the cell make contact with the plates inside the cell and get their power from them, dirty contacts in any part of these contacts will cause the problem. Even a bad contact from the end cap to the plates inside the cell will cause this. Try wiggling the cell around, kind of push on it on edge to get the plates to shift slightly and clean the points where the plates touch the outer strips on the sides. Check for arcing with the lights turned off,

Oct 20, 2014 | Oreck XL Professional Air Purifier

1 Answer

Fresh air 2, blue light goes out, fan still works, reads


If the light goes out, it is time to replace the bulb AND the bulb starter. They need to be replaced every two years. Beyond that, they are an expensive night light. If you need to order one, call (336) 499-2505. Also ask for supplemental cleaning instructions since the original instructions are incomplete.

Jun 10, 2012 | Ecoquest Fresh Air Air Purifier

1 Answer

"Cleaning overdue" red blinking light after cleaning was done


Check that there are no fine pieces of lint that are bridging the plates or the ionizing wires, to ground.

Check the contact points of the collector cell and inside the unit.

The light is caused by a shorted collector cell and associated components.

Dec 21, 2009 | Sharper Image Ionic Breeze GP SI730 Air...

1 Answer

After cleaning red cell light wont go off


This red light goes on when air purifier needs to be cleaned, also check out whether fan is running or fan is stopped if fan is not running and red light is on then the problem is of filter got wet inside.let the filter get dry then check out.if still the same problem the filter needs replacement. to remove the filter for cleaning or replacement Remove the ESP cell by taking hold of the handles and lifting upwards. and then Remove the Oxygen Plus filter from the unit.by lifting it up slightly. its the filter problem either its wet and needs to be dried out or the filter is got clogged by dust and needs replacement.contact the local service center for air purifier and get the replacement filter.------ This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya.

Nov 24, 2009 | Oreck Super Air 7 Air Purifier

2 Answers

Red Light


slow blinking light means the unit is in DRY MODE.. flast blinking light means some sort of arcing or bad power supply..
if in dry mode let the unit run for an hour and it will stop blinking ..

Jun 28, 2009 | Oreck XL Professional Air Purifier

1 Answer

Clean cell now flashes after 20 minutes


The previous suggestion helped me because as I was examining the cell for debris I noticed markings for "Top" and "Bottom" inscribed on the four corners of the front of the cell that I had never noticed before. After cleaning I had installed the cell upside down. It would work for 20 minutes and then shut off. The rounded thingies on the bottom of the cell are contacts which should touch the little springies on the bottom of the housing.

Jun 03, 2009 | Kenmore AC2044-1 Air Purifier

3 Answers

Replaced RCI Cell 2 times, light still doesn't come on


The U.V light is inside the RCI cell. If you replace the RCI, it has been ok. Please don't mind the screen display.

Oct 09, 2008 | Ecoquest Fresh Air Air Purifier

2 Answers

Red light wont change back to green after cleaning


I did the same thing and now I need to replace the cell collector. You need to replace it to if the wire is broken. Please let me know the outcome of your problem.

Where to find the part is hard to get.

animallover2

Jun 05, 2008 | Oreck XL Professional Air Purifier

2 Answers

Kenmore ac2044-1 shuts off


Take Cell out and examine closely with flashlight for debris and bent aluminum cell plates or ionizing wires.

Make sure all plates are more or less clear of one an other with fairly even spacing between them and no kinks on their edges.

If any are to close together it will cause a cell overload that will cause the Clean Cell to display and or completely turn unit off all together.









.

Mar 28, 2008 | Kenmore AC2044-1 Air Purifier

Not finding what you are looking for?
Kenmore AC2044-1 Air Purifier Logo

Related Topics:

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Air Purifiers Experts

Fordexpert

Level 3 Expert

5331 Answers

kakima

Level 3 Expert

96738 Answers

Michael Youngman
Michael Youngman

Level 2 Expert

156 Answers

Are you a Kenmore Air Purifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...