What is f17 error? - Fisher and Paykel E522B Stainless Steel Bottom Freezer Refrigerator

Hello Janiel;

My name is Peter. I am a retired field service appliance technician.

I pulled up the tech manual for the unit, and there is not an f17 error code applicable for this model. the two closest errors I see are either f11 (shorted keypad or selector switch) or f12 (eoc internal software error or failure).
we recommend verifying the error code to see which it could be and repost your inquiry if needed so we can look into possible solutions.

Also, your model number does not register and is incorrect.

Hi Craig,here's a link on your F17 code. Appliance Fault Codes AppliancePartsPros com

F17 is a time out fault on drain pump. Check all water hoses and drain pump for either blockage or restriction. Failing that, check your waste pipe is clear.

sorry no i/we dont know i have seen this question in mant various froms here this morning we all know F25 code but i and suspect everyone has no idea what the F17 means since i have seacrhed and can not find any reference to it anywhere on the various sites i use to look up Whirlpool Duet error codes...nor in my years in the fileld servicing Duets have i ever seen the F17 code

Hi from retired Englishman in SW France,

My list for Siemens/Bosch states 'F17' as being 'inlet valve problem'. Sorry- service call ;-0(

If this has assisted and/or clarified the situation for you please consider a 4 thumbs up on our rating.
Thanks and good luck!
John C

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light

If you open the washing machine you will find a packing slip with all the information on the error codes and electrical schematic. F17- covers the following problems - supply hose kinked/jammed, clean filter, water pressure too low..hope this helps

F17 is a water pressure error not enough water pressure.

I had this same message last week. It is to do with the water intake (i.e. the water coming in to the back of the machine). If you have checked that the hose isn't trapped or kinked, unscrewed it and checked the filters at each end for blockages (rinse out if necessary), and you still get the F17 message, it may be because your water pressure is too low, in which case you need to contact your landlord (if you rent) or thames water if the problem is external (especially if there are any works going on near your house). Hope this helps!