Inktank obsorber - Canon Office Equipment & Supplies

Probably your printing heads or your ink has dried out. Try to clean the printingheads with a cleaning tissue and a cleaning fluid. If it doesn't work you need to replace the inktanks. The printinghead is a part of the inktank. It is the gold-colored part with the dots (the dots are actually the nozzles).

printer says"waste inktank near full" Alarm light blinking.

there is a gadget sold on eBay (I got mine in England but it came from Hong Kong!) it re sets the chips in the cartridge.

try restarting the whole unit system(pcand printer)

hi
it's show u a red/orange light blink it's show u hae a refield cartig insarted u need to press red light buttons for 5sec. and then light blink off and only green light only show now give pring if again orange light blink press 5sec. don't give any kind of link on show messages in windows it's gone automaticaly if u have any quary please tell me...

thanks
jo_chinmay

Try the procedure listed on this page:

http://www.askanowner.com/qa/view.asp?s=1&qid=201364

Page down to see the info you need.

May be time to replace the print heads as a new unit is quite pricey. Refurbished from canon is about $150.00, print heads are about $50.00

link

visit www.driverguide.com

have u switched the printer ON? plz do and the the ink tanks will come in the middle.

well? how old is your printer?. does your printer head is new?
reason why doesnt have printout:
1. the unit doesnt recognize the printer head:
solution: turn off the unit and turn it on again.
2. Defective logic board.
solution: replace logic board.
3. Defective printer head
solution: replace printer head
4. Clog printer head
solution: wash the printer head with water..make sure to dry
before you install it to the printer.
5. Defective purge unit.
solution: replace purge unit.maybe it wont suck ink because of the loose or broken springs under caping of the purge unit..
6. inktank.
solution: check the lips of inktank maybe it much shallow so it
wont touch the nozzle of printer head..
you need to cut the edge of the lips of inktank so it will touch
the nozzle of the printer head.