Question about Projection Televisions
You may have a convergence problem. Here are some of the most common symptoms and example photos.
Here is a quick test....
Using your original remote go-to the tv settings then goto the convergence section.
Try to adjust the red and then the blue convergence.
You should be able to move them up, down, left, and right.
If you can't move them in all directions your convergence chips are bad and should be replaced. This is a common problem.
You need to replace the convergence chips and convergence resistors. Check the site www.TvRepairKits.com. They have put together a kits for most models. If you don't see a kit for your set send them a quick email and they will put one together for you. Their kits includes photo instruction guides, original Sanyo STK chips, convergence resistors, pico fuses, etc.
Posted on Feb 05, 2009
SOURCE: sony rm-v210 codes
According to the manual it is 8083.
You can download the manual on this link. You don't need to put in your email address to download, I didn't.
Just click on get manual then follow the download instructions minus your email, but you have to put in the numbers just above start download. These number keep computers from automatically downloading and crashing sites.
I hope that I have provided the correct information that will assist you in the resolution of this issue. If you have any questions, please post back with a comment to this thread.
If I have helped you with your question and/or solved the problem, please take just a moment to rate this post. Thank you!
I try to provide the best FixYa experience.
Posted on May 10, 2009
SOURCE: pip pictture doesn t turn off
I had the same problem many times, and I don't have the original remote. Go into your menu options and select Auto-Program. It will run through all your channels, but when it is done, PIP will be off !! I have PIP!
Posted on May 21, 2009
Sounds like a bad tuner/decoder on the Qam analog side of things. You can bypass this with a Clear qam converter box or a analog to digital tuner box or simply having this repaired upwards of $200 bucks.
Thanks for using Fixya.com
You're Toshiba Tv Expert.
Posted on Aug 31, 2009
You may wish to clear the remote's memory before starting. Slide the top left switch to "Learn." Press ANY button on the remote, do not worry if the indicator light flashes. Press the "Program Clear" button. The indicator should flash 4 (maybe 5?) times. You are now ready to program. Make sure the switch is in the "Learn" position. Place the rm-p311 and the remote you want to program in about 2 cm apart facing each other. Push the button you wish to program on the rm-p311. The indicator light should come on with a slight delay. Press and hold the button on the other remote until the indicator light goes out. Put the slider back to "User" mode and test it! For more info., go to sony's support site and search for the user manual for the STR-AV1070 receiver. It contains instructions for the remote.
Posted on Aug 20, 2011
Tips for a great answer:
May 17, 2014 | Projection Televisions
Nov 28, 2012 | Projection Televisions
Nov 19, 2012 | Projection Televisions
Oct 20, 2009 | Mitsubishi VS-45605 50" Rear Projection...
May 10, 2009 | Projection Televisions
255 people viewed this question
Usually answered in minutes!