Question about Washing Machines
I went to the LIBRARY and checked out a book on Washing Machine Repairs. It had all types of makes and models of washers. The book listed problems that can occur and solutions with complete diagrams of all the parts how to take the machine apart and put the replacement part in and put the machine back together. This all in a book I checked out from the local LIBRARY FREE of CHARGE. I'm going to spread the word that you don't have to pay for information on anything, JUST GO TO THE LOCAL LIBRARY. What a wonderful service they offer to all citizens.
Posted on Jun 26, 2008
This problem is usually caused buy the switch that the door must activate when its closed for the spin cycle for safety reasons. Either the screw mount breaks or the switch just fails there usually between 30-50$, very easy fix.
Posted on Jul 09, 2009
My washer would not drain or spin. I found that the probe on the door was not pushing the limit switch down far enough. I put a 1/4 inch extension on it and it now works.
Posted on May 11, 2009
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Jul 07, 2017 | Kenmore Washing Machines
on Dec 12, 2017 | Washing Machines
Dec 10, 2012 | Kenmore 3.5 cu. ft. Front Load Electric...
Oct 08, 2012 | Washing Machines
Oct 08, 2012 | Asko W6021 Front Load Washer
Sep 10, 2011 | Kenmore Washing Machines
Error code FH appears when No water is detected entering machine or Pressure switch trip is not detected. If after 30 seconds the control does not detect water entering machine and then valves will be turned off and the error code will be displayed. Press PAUSE/CANCEL twice to clear the display. If there is no water entering the unit then make sure that the inlet valves are working fine. You may need to check the continuity at the inlet valves. If the valves are fine then check whether inlet water hoses as they might be plugged. Also check for inlet water screen at the valve. However, if the water is entering into the washer then the Drain pump might not be working. Also inspect the Pressure Switch hose whether it is in good condition and properly connected to Tub and Pressure switch. Also check hoses for leak and inspect the flow meter. Hope this helps...
Aug 31, 2011 | Kenmore HE2 Plus Front Load Washer
Nov 29, 2010 | Kenmore HE3T Washer
374 people viewed this question
Usually answered in minutes!