Question about Speed Queen AWS75NW Top Load Washer

1 Answer

Speed Queen Top Loader heavy duty washer

The washer seem to be going off balance in spin mode.This cause the machine to move and shake.What can the problem be?
thanks
Rick

Posted by on

  • Anonymous Mar 18, 2014

    filters on speed queen top load washer

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 172 Answers

First unplug the machine, now take off the front panel, two screws at the bottom of the front panel, front panel swings up and off.

check to make sure the six springs are still in place.

Under the tub is bearing housing between the tub and base usually white in color, under this is a plastic ring, does it seem to float easily when you move the tub. it could be broken. Also look around for loose or missing screws.

If all seems fine, make sure you have all four rubber feet on, level machine, in the front first side to side, then pull machine toward you to bring rear legs off floor, these are self leveling, have someone assist and make sure they are not stuck, use a pliers and break loose if they are. So with the machine on its front feet and the back feet off the ground set the machine down on all four feet check level front to back adjust as needed on the front legs. You should reset rear legs as you adjust the front. now with machine level tight the nut between the front legs and the base locking them.

This should help, if machine still shakes it could be the balance ring, has lost if solution its filled with a salt water solution, the hard part is you need to find it under the tub cover. we will go into the detail if we need to. ask more questions later

Posted on Jul 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speed Queen Model RWM274W-3062 top loader.Stops spin cycle after about 20 sec.When i open and close door it spins again for about 20 sec then stops. What could be the problem, thanks


Washing machines kick off when they're out of balance, like if something is too heavy and waterlogged on one side. Redistribute the laundry and it will be fine.

Mar 09, 2016 | Speed Queen Washing Machines

1 Answer

Kleensmaid heavy duty washer by speed queen, washes but shuts down on what seems to be overspeed on the spin cycle


Amazon.com: Customer Reviews: Speed Queen 3.3 Cu. Ft ...

www.amazon.com/Speed-Queen...Washer/.../B004ZO...

Amazon.com, Inc.Find helpful customer reviews and review ratings for Speed Queen 3.3 Cu. ... If you need more water in the tub you can hold down the reset switch until the machine ... I tried the delicate wash and spin cycle, but the clothes retain too much water and ..... It takes time to correlate the number of turns and the direction to turn it.Missing: overspeed

Commercial Washer and Dryer Problems

www.affordablelaundry.com/commercial-washer-and-dryer-problems
The water should shut off once it reaches wash level, if it doesn't, and water level hasn't... (these are the glass type fuses) be sure to turn power off before checking them. ... If you have the voltage in, but not out, it's the contactor. .... We repair: Speed Queenwasher, IPSO washer, Milnor washer, UniMac washing machines.Missing: overspeed

[PDF]View document in PDF


Dec 19, 2015 | Speed Queen Washing Machines

1 Answer

Good day, can you please help, I want to know what can be the problem. Our speed queen heavy duty washing machine leaks water when spining. The water leak is at the top of the outer tub where the clips...


The basics would be make sure it's clean, the outer and inter ring of this area holds and builds up dirt and debris over time, causing a bad seal, also has to spin and be balanced properly or it will leak a little. ...

Feb 26, 2015 | Speed Queen Washing Machines

1 Answer

Won't drain - no pumping sounds at all


if agitates an does not spin means is not going to drain, cause for not spinning broken door switch, look an see if you can feel it hanging or loose, if the swtich is broken it will not go into spin mode at all...........door switch is a safety device!

May 27, 2009 | Speed Queen AWS45NW Top Load Washer

1 Answer

Shake when spins even when no clothes in it


Make sure the lags are solid to the floor. Any bit of difference will be exagerate when the washer spins. put a piece of paper under each of the front legs. While the washer is spinning try and pull the paper out. If you can pull the paper out with no problem, that leg needs adjusted to the floor more. If Ican help further, please let me know

THanks
Vic

May 15, 2009 | Speed Queen ATS90AWN Front Load Washer

2 Answers

Washer shakes on spin cycle


2 possible causes 1 cleanout filter and check water is pumping out properly before spinning

2 check the suspension legs at the base of the tub for wear or damage.

Oct 29, 2008 | Speed Queen AWS52NW Top Load Washer

1 Answer

28+ year old- Speed Queen Heavy Duty top loader


It sound like you drain hose is siphoning off the rinse water, It needs a standpipe make sure the drain hose is at about the height of the top of the washer, Make sure the drain hose isnt stuck in the drain it also needs an air cap. the drain hose should not lay on the floor to run to the drain

Please let me know if this doesnt solve your problems

Aug 31, 2008 | Speed Queen AWS52NW Top Load Washer

1 Answer

Kenmore washer out of balance


go to sears.com and find the parts listing for the 110 model number you have listed above .http://www.searspartsdirect.com/partsdirect/retrieveModelActionHome!retrieve.action;jsessionid=8mJfynqZfmsdSyTnd9kaQw**.shcapp3005?modelNumber=110.16502694+&pop=flush

You might need one of the springs. unplug the washer and take the cabinet off first. look around for broken or missing parts

May 12, 2008 | Washing Machines

1 Answer

Admiral Heavy Duty 22lb. 2 speed motor going off balance


Had Same problem. Replaced The 6 retaining springs and snubber.
$15.00 worth of parts.

Dec 22, 2007 | Admiral AW22 Top Load Washer

Not finding what you are looking for?
Speed Queen AWS75NW Top Load Washer Logo

1,296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Speed Queen Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Chris Hall
Chris Hall

Level 3 Expert

842 Answers

Are you a Speed Queen Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...