B572 Tec I want to update my B572 to Windows XP. How can i do it?

document properties, support, check if the label detection is transmission and not none

As a metter of fact, yes there is a cell detecting the gap.
You must turn the Green knob so that the detecting cell is on the notch. You must program the height of the label and in the driver you must give the size of the notch in the Support Tab.
D'ont forget to alse specify if it's direct or thermal transfer.

I think this is a Q-tec 100 webcam ..and it should install by itself in windows 7 and vista ..Im not sure about windows xp ..and here is a driver to run it on xp if it is the case..If it is not running on windows 7 ..and you need the driver ..download this one ..and select on its properties to run in compatibility with windows xp ..and will work .
http://drivers.softpedia.com/get/SCANNER-Digital-CAMERA-WEBCAM/OTHER-SCANNERS/Q-Tec-Webcam-100-USB-Driver-10.shtml
let me know what you've managed to do ..

Check this answer at answers.microsoft... it may be as simple as turning off your antivirus while installing these update. You may also try the installation in Safe-mode.

Download one of the following drivers. Choose the operating system you're using:

- Windows XP
- Windows ME
- Windows 98
- Windows 2000

If your OS is not listed above then it's not supported. If you're running Windows 7, download from any link and run in compmatibility mode. You should be ok.

Hope this helps.

You have security rights problem.
Check with your administrator

Check your rights

Visit the http://www.brother-usa.com for updated drivers and manuals

Once on the site just click the Drivers and Downloads button.

Does windows always have this problem? I think it can be fixed through a <a href="http://www.pcaholic.com"> computer check up</a>. Might want to have a good look at the website <a href="http://www.pcaholic.com"> http://www.pcaholic.com</a>.

Download from this link service pack 3