When the camera is turned on, the lens is stuck either in or out and the camera gives the error E104 , E105 , or E106 . The camera then turns itself off.
Causes
These errors display because the lens will not move. There are several reasons why the camera lens might not move:
something is blocking the lens
the firmware version is old
the camera has been abused
foreign material is inside the lens
or
the lens is loose or completely off the track
Solution
Follow all of the steps listed below.
Perform a power reset on the camera.
Turn off the camera and remove any optional memory card.
Hold the ON/OFF switch in the ON position until the HP logo displays and then disappears.
The camera is now reset. When the camera is turned back on it should prompt for the date and time.
If the camera does not display an error after the reset and appears to be functioning properly, it is imperative to check and update the firmware. The firmware update corrects the lens positioning issue that can cause E104, E105, and E106 errors with the camera.
Determine if an update is needed by following the steps below to check the current version of the firmware on the camera:
Before turning the camera on, press and hold the Flash button.
While the Flash button is depressed, turn on the camera. A Service Screen displays.
Located at the bottom of the screen is an entry, F/W.
Display zeigt Zugriff an. Kammera aus/einschalten. Hilft leider nichts. Wie kann das Problem...
(More)
Display zeigt Zugriff an. Kammera aus/einschalten. Hilft leider nichts. Wie kann das Problem gelöst werden.
Add the things you own to your My Products collection and get product information, solutions to problems, manuals & guides, tips and how-to's, reviews & ratings and local repair service - all in one easy place.