Question about Routers

2 Answers

Internet connection via wireless router

Have followed instructions and being informed I am connected, I am unable to connect to the internet via Explorer because I keep getting the old modem dial up connection instruction, which of course no longer applies, how do I get past this.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

When i used to run the CD that contains the driver of my router, i can not longer access the whole installation because they recommended a password. what should i do?

Posted on Oct 11, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 176 Answers

Change the settings in explorer ... Tools- Internet Oprions- Connections

Posted on Jun 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a d link d1 514 router. I'm unable to open 192.168.0.1. if i put the internet connection wire in LAN then I'm able to get internet access using cable but if i put the wire in wan, I'm not getting...


carry out the resetting of the dlink router
then use lan cable to gain access to dlink router,
set up the internet conenction (i.e. your internet provider modem plugged into the dlink router also)

if it has a built in wizard then just follow the on screen instructions

you will need to define SSID (wireless network name) and passkey (password for the wireless connection)

and the your done. disconnect the laptop from wired connection and connect via wireless

Oct 16, 2010 | D-Link Dlink DI-514 Air Wireless 2.4 GHz...

1 Answer

Frd gVE ME A WGT624V3 router. however i do not have a cd. I connect all the wires as instructed from the manual online. when i connect to the either wireless or lan, i have no internet connection. I have...


1. Each wireless device has to be allow to connect to the router via a specific IP address assigned by the router in its router table.
It also can setup a wireless device, such as a laptop or phone via a MAC Address ( Media Access Control) number that is assigned to almost every wireless device.
Here is an instruction set to follow to set up your wireless device in your router ( it is generic but works).


.Log into router. Using either 192.168.0.1 ot 192.168.1.1 in a browser window that is ( internet Explorer or firefox)
2. Verify wireless router name( on the computer) >>> ( on/off) ( router status window)
3.Note router name you are connecting to.
4.. Check the laptop do ipconfig /all to see current IP addresses.
5. Set the laptop up in the router by WEP KEY or MAC address. This set up in the "security tab" in the router. using 192.168.0.1 or 192.168.1.1 to access through a browser.
6.Note router name you are connecting to.
7. Move the laptop about 20ft away and try to log on to the internet.
This is for all routers to set up wirelessly.

Aug 30, 2010 | Routers

1 Answer

Wireless connection problem


That is the correct access IP address to acces the router properties.

If its a forgotten password you will need to "reset" the router to default by straightening out a paper clip and insert it into the rear of the router till it reboots.

BEWARE this will wipe username and password for the internet and security key. If you dont know your U/N and P/W then call the ISP to reset it.

To enable the above access the router by using the above IP address and re-insert U/N and P/W.

Access security options in the router menu and follow instructions to recreate security password.

Apr 27, 2010 | NetGear WGR614 54 Mbps Wireless Router -...

1 Answer

No Internet Connection with Zoom 4501 & HUAWEI K3520 3G Dongle


If you connect the computer directly to the modem, does it work?
If that works then the modem is working.
Now connect the computer to the router and the modem to the router.
You will need to open the set up page of the router to check the settings of the router.
You can set up the router without the CD also.
It is very easy.
Click Here for step by step instructions about how to set up the router

Dec 14, 2009 | Zoom (5590-00-03) Wireless Router (G66115)

1 Answer

Cann't get my wireless router to work,don't understand how to config the router.


HI helock,

This is a step by step instructions:

Note: It is recommended that you configure the Wireless Router from a wired
computer.
1. Open your web browser, type http://192.168.10.1 in the Address bar, and then press Enter.
2. Enter the User Name and Password, and then click Log In. By default: User Name: admin Password: admin
3. The Wizard will automatically appear. Click Wizard if the Wizard does not automatically appear.
4. Click Next.
5. Select your Time Zone and then click Next.
6. Click Next. Note: Do not change default settings unless it is conflicting with your existing hardware.
7. The TEW-432BRP will attempt to auto detect your Internet connection. Follow the wizard instructions and continue on to step 9.
8. This screen will appear if the TEW-432BRP is unable to auto detect your Internet connection. Configure the settings based on information provided by your ISP.
9. Follow the wizard instructions to complete the configuration. Note: Each Internet Connection type may have different options.
10. Click Next
Note: It is recommended that you enable encryption on the wireless router. Please refer to the User Guide on the User's Guide CD-ROM for information on
setting up encryption on the wireless router. 11. Click Restart. 9. Follow the wizard instructions to complete the configuration. Note: Each Internet Connection
type may have different options.
11. Click Restart
12. Click Close.
13. Wait 30 seconds while the router reboots.
14. Verify that the following panel lights are on: LAN, WAN and WLAN.
15. Open up your browser and enter in a URL (e.g. www.trendnet.com) to verify that you have Internet connection.
Your configuration is now complete.

Good Luck,
And don't forget to leave a rating

Thanks

Mark

Sep 14, 2009 | Trendware TRENDnet TEW-432BRP 54Mbps...

1 Answer

Unable to connect wireless


Since you are unable to go via wireless, follow these steps:

1) Access your router configuration pages by typing in 192.168.1.1 into your web browser.
2) Click the tab that says Wireless.
3) Make sure the wireless broadcast option is enabled. If it isn't, enable it and select save settings.
4) Set up the wireless network through your Vista PC by going to Start > Network.
5) At the top of the window, select add a wireless device. Follow the onscreen instructions to add your Linksys Wireless Access Point.
6) Once added, right click on Wireless-G Router (name varies) and select configure. Follow the onscreen instructions to configure your router. (You can find your router pin by following steps 1-2 and selecting Wi-Fi Protected Set up.)
7) Once completed, attempt to connect to the internet via wireless router.

Dec 15, 2008 | Linksys Wireless-G Broadband Router

2 Answers

Unable to connect a WGR614 Wireless Router to a DM111P Modem


Sounds like you need to port forward your router. Go to port forward .com. find your router and follow the instructions. Hope this does the trick for you.

Nov 26, 2008 | NetGear WGR614 Wireless Router

1 Answer

Wireless internet connection


Fog will not affect radio signals. Please go to the following website and follow the instructions.
http://kbserver.netgear.com/kb_web_files/n101676.asp

Oct 30, 2008 | NetGear WGT624 Wireless Router

1 Answer

I have purchased a Belkin Wireless G Router for a cable modem. I have installed however i am unable to see the wireless network. What have i done wrong ??


Hello experts....

My problem is not being able to work wirelessly with my laptop. My answers to your questions are underlined(I've used your questions to someone elses problem)

One possible issue is your router's wireless radio is not enabled- the light on the router is lite on the symbol for wireless

or the wireless radio is not enabled on the computer you are attempting to connect to the router with - there is a switch on the front of this machine which is switched to wireless.

There are many other possibilities as well. That is why we need you to carefully answer EACH ONE of the following questions.

(01) Which of the following is your router?
-->> F5D7230-4 (Wireless G Router)

(03) Are ANY of the computers connected to your Belkin router able to access the Internet?
YES

(04) If there are other computers connected to the router that are able to access the Internet, how are they connected? (in each case, please)
only this machine is connected but it is by....
(b) wired (using an Ethernet patch cable connected between the router and the computer)

(05) What is the manufacturer and model number of the computer you are attempting to access the Internet via the router on?

HP Pavilion dv2500

(06) What operating system is installed on the computer you are attempting to access the Internet via the router on?

This machine is operating on Vista but the internet access I have is with talktalk

(07) Have you ever successfully connected (wirelessly) to the Internet from the computer you are attempting to wirelessly access the Internet through your Belkin router on?
NO


I hope you don't mind me using your questions to someone else, I thought you might be able to figure out what I'm doing wrong. I am connected to the internet but don't seem to be able to work wirelessly. Lorraine

Apr 09, 2008 | Belkin (F5D7230-4) Router (587009)

1 Answer

Iam not able to connect to internet via wireless router


Need more information to help you.

1. If not using the router at all is there connection to the internet??

2. When working woth a utp cable between computer an router is there internet connection??

Don't forgett getting connection with your wireless network is not the same as gettin connected with the internet.

Suggestion: Clone your computer MAC address in the router.

Jan 23, 2008 | Linksys Wireless-G Broadband Router

Not finding what you are looking for?
Routers Logo

Related Topics:

421 people viewed this question

Ask a Question

Usually answered in minutes!

Top Routers Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18297 Answers

Mike

Level 3 Expert

4331 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a Router Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...