I have an equator washer/dryer combo. It seems to have a few problems. The washer doesn't spin during the spin cycle, although it spins during the rest of the wash cycle. The pump is making a weird noise. Also, at the end of the cycle the washer doesn't stop. The motor is on, but again there is no spinning. I checked the hoses and there is nothing inside. The dryer spinns but it doesn't stop at the end of the cycle. In fact it stops spinning and i can hear the same noise that i hear at the end of the washer cycle -motor running. Do you think it is just the pump causing all these?

Question edited for clarity 'make model (what it is).
Question moved to Frigidaire Washing Machine.

This is the Transmission unit, which I would say puts it beyond economical repair.

Frigidaire H Transmission #WCI-134735700
List Price: $765.13
Sale Price: $637.61

On first reading, I thought it sounded like the pump, but then no agitation, but it spins. This makes it sound like the control board. In view of the confusing actions and the cost involved, I would call out a Service Engineer.

https://www.partswarehouse.com/Frigidaire-FEX831FS2-Washer-Dryer-Combo-s/70205.htm

..

http://www.fixya.com/WrnModule.aspx?prdid=42469

cheak this out once

If you can make the motor spin a few revolution by manual intervention, then the issue is most likely a faulty motor 'start' capacitor which is located near the motor: this replacement involves a dangerous MAIN AC VOLTAGE device and I would advice getting a qualified technician to check/repair your dryer.
Hope it helps.

It's possible that the tub didn't drain properly in the allotted time and the remaining water is slowing your drum from coming to maximum extraction speed.

Hello.
Noises are common when using a two-in-one washer and dryer, as clicking or whirring is part of the cleaning process during the transition to the next cleaning process. The GE Spacesaver washer and dryer combo uses a top-loading washer stacked beneath the front-loading dryer, and uses an agitator that makes noises throughout the spin cycle. Although whirring or clicking is normal, other noises or malfunction indicates a problem with the washer that requires minor troubleshooting. Professional repair is necessary if the washer continues to experience problems during the spin cycle, as there may be a problem with the washer's agitator.
1 Open the washer's door and check the balance of the load's clothes. Clothes that are unevenly distributed around the agitator cause excessive shaking and result in an imbalance during the spin cycle. Reduce the load's size by removing clothing if the washer's drum is overloaded.
2 Push "Start/Pause" to pause the spin cycle and turn the washer's cycle knob to the "Off" position. Turn the knob to "Spin Only" and press "Start/Pause" to reset the cycle.
3 Turn the wrench counterclockwise or clockwise around the unit's legs to adjust the appliance's balance. The legs are adjustable with the help of a wrench to ensure the unit does not shake while in use. An unleveled unit shakes as it spins, and causes excessive squealing or rattling as it attempts to dry the clothes.
4 Touch "Start/Pause" on the front of the washer's control panel and unplug the washer/dryer unit's power cord from the electric oultlet. Wait two minutes and plug the power cord back into the electric outlet. Push "Start/Pause" to resume the spin cycle.
Thanks.

more likely an itntermitent lid switch problem as the washer strats it's spin cycle the motion is causuning the lid switch to open making the washer think some one has opened the lid and it shuts down to be safe check the switch make sure it hasn't come loose and check the actuator on the lid sometimes a plastic piece near the front of the lid that goes into sort of a key hole Good Luck

Try looking to see if the little motor is spinning the drain pump. It is in the bottom right. Occasionally I get a small metal shard which locks the pump and therefore-no draining. You can undo everything and check the pump for blockage. Then if need be, replace the mechanisim. The parts are all on line, as is the manual. or call 800 776-3538

That's the way it works, kinda stupid, it would be good if it did that at first to loosen up clothes in case they're stuck to the drum but then move like a traditional dryer but that's just the way it is. BTW, here's a website with parts for it in case you need them. I never used them but just found them, I was lucky I never had any problems with my equator until now but I kinda can live with it (during rinse cycles it pumps water out but then when it does the short spins it does not, so rinsing is not as effective sinse it leaves a lot of dirty water in and then puts fresh water in and does it again, it does pump the water out during the final spin cycle though). Anyways, good luck. I bought mine in 2001 or 2002 and never had any problems except for the one I mentioned.

Are you connected to a 30 amp breaker w/ 30 amp wire?

No - the timer is the likely suspect.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.