Camcorder is DEAD, need to get the tape out!

I think the battery failed, I would replace the battery. You can buy the battery by number (battery info is printed on the battery) on eBay.

I would not recommend trying to remove a tape that is stuck Because the eject and load mechanism is controlled by a motor and you have to supply voltage to in the correct polarity to get the camcorder to take the tape in or eject it, that means that you would have to disassemble it.
That is the case with all camcorders - analog, digital, new or old. If you need the tape I suggest sending it in to a shop If you can do the repairs yourself
Dismental the camera. Try to locate the power board. have a look at the components near the battery connector or the power connector. there you will be able to locate 3 to 4 safety fuses. check the continuty. if found open replace it or jump them and and try to eject it.
you can also try to locate the motor for tape deck loading mechanism. Remove the flex ribbion connector of the motor from the pcb, then try giving 3 volt supply from an external device to the motor in both the direction. in one direction it will move the deck outward, but be carefull when the cassette is being ejected a little portion of the tape may get damaged.

Sony Handycam CCD-TRV58 Hi-8 Analog Camcorder
1. Per the manual on esupport.sony.com
- if the power is disconnected door won't open, and if the battery is the dead the door won't open.
Plug it in and hopefully you can get the tape out.

Did this work?

It sounds like your battery is bad, or dead. Try charging the battery. If it won't take a charge, replace your battery.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Sounds like you have a "dead" camcorder. This can be caused by a circuit protect (tiny fuse) being blown or a bad board. This will need to be repaired by an experienced technician. <a href="http://www.austintelstarservices.com">www.austintelstarservices.com</a>

My friend went back to England and got it sorted there
Thanks

a

Intermittent fault? Playback of recorded footage not possible.
Even tried to check 'playback' with an older tape.

can you plug the camera into an electrical outlet and eject the tape that way?

FG fault when starting capstan.

Make sure battery is fully charged or a/c cord is used. Turn power on, and push reset button, try to eject tape again. Your capstan motor may be dead.

The tape might be wrapped around the head or the capstan. The mechanism is delicate so you risk more damage by trying yourself - check with some of the repair shops on the Fixya home page for prices to remove the tape.