Question about Denon AVR-1907 Receiver
I have a Denon AVR-1907 receiver that is hooked up to a Main Zone and a Zone 2. The Main Zone works just fine but when I what to listen/power to Zone 2 the whole unit shuts off and the power on/off button blinks red.
It sounds like you have a bad speaker on the zone 2, or you have the speakers connected improperly.
When you engage the zone 2 a relay clicks and the speakers then become part of the amplifiers circuit.
If the problem was in the amplifier, it would go into protect mode without even having speakers connected to it.
If the speakers all check good, you most likely have the wrong type of speakers, meaning the impeadance is too low, or you have too many speakers connected to it.
On the back of the Denon, you will see right around the speaker output jacks, what ratings the speakers should be. If I remember correctly, it says 6 ohms or more when using only "A" or "B", and it says 12ohms or more for "A" + "B".
If you have two 8 ohm speakers on the same speaker jack you now have a 4 ohm load. That is below the ratings and can cause the amp to shut down (go into protect). Since your amp shuts down right away, I think you have a bad speaker or way too many speakers connected.
I have seen many times when people will connect 2 or 4 speakers to the one of the outputs that are designed for only 1 speakers.
If you are using too many speakers you will need a speaker distribution box. It has a resistor network built into it so the amp never sees a lower impeadance than what it is designed for.
You can connect 4, 6 or 8 speakers to one set of outputs designed for 2 speakers. You do loose a lot of power to the speakers, but it is better than blowing up your amplifier.
If I can be of any further help, let me know.
Posted on Jun 22, 2008
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Jul 01, 2008 | Denon Audio Players & Recorders
Nov 11, 2013 | Denon AVR-1907 Receiver
Sep 26, 2011 | Denon AVR-1907 Receiver
Jan 16, 2011 | Denon AVR-1908
Dec 28, 2010 | Denon AVR-1907 Receiver
Nov 22, 2009 | Denon AVR-1907 Receiver
Sep 29, 2009 | Denon AVR-1907 Receiver
Jun 14, 2009 | Denon AVR-1907 Receiver
Jan 03, 2009 | Denon AVR-1907 Receiver
2,100 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: