Question about Tower Aloha Breeze Fan

1 Answer

Does the aloha breeze fan take water?

The fan is leaning and there is a "push" on top that opens - someone suggested it takes water ???

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

That button is for the remote control. Push where it says push and you will see a small space for a small remote.

Posted on Jun 29, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Thermostat replace


thermostats are always a common culprit for over heating but outer items like poor fin condition on the cores , blocked or partially blocked cores, lack of anti freeze -anti boil coolant, coolant fan not working. timing problems with the ignition, air -fuel ratio not right (too lean) gear selection ( OD not working) fan belt loose. A simple test for a thermostat operation is to start the engine cold and time how long it takes before you can feel hot water in the top radiator hose . 10 minutes at idle would be about right and if you feel the hose start to get hot then the thermostat is opening

Dec 16, 2013 | 2006 Mitsubishi Lancer

1 Answer

Loud banging noise whilst drum is turning to dry


hi put you hand in drum at the top at the back get someone to lean on top of dryer see if you can push drum upwards if so you need to change rear bearing if you do there is a cover in centre of the back held by two screws you will see a pin going through the shaft pull it out take bearing out some have a skrew holding it in to put new one in take lid off so you can pull drum up to push new one in place put pin and cover back its quite easy hope this helps

Jul 31, 2013 | Hotpoint Dryers

1 Answer

Door and handle problems. Smeg fa311x


sounds like your door is sprung. take door off and lay flat on a table outside of the door down. loosen screws on door liner . screws are hidden under door seal. when all loose not removed make sure door is flat on table. tighten the screws being careful not to move door. reinstall door and it should be ok. this is usually cause be either someone leaning or hanging on the door when it is open. or putting to heavy of items in the door trays.

May 26, 2012 | Smeg FA311X Top Freezer Refrigerator

2 Answers

How do I take apart my fisher & paykel top load washer to get to the water pump. I have an error code 37 which means blocked water pump


Hi just read your posting.Now if you look under the machine to the front right you will see a fan.This is your pump.Turn the fan a few times to loosen it.The fan should turn freely.Put the machine back on its feet and select a spin cycle and push the start button.The machine should start to drain.Please reply on how you got on or if the machine still does not drain or for further assistance.Looking forward to your reply.

Oct 07, 2010 | Fisher and Paykel GWL11 Top Load Washer

1 Answer

Aloha Breeze 16" Vintage Stand Fan Model #46051 (46052) Serial #03156: Trying to open up the case to get to the motor, to try and replace a fuse or something that's making the fan not work. I got the...


It isn't worth fixing. I am on my second one which didn't last any longer than the first which was about 3-4 months. These fan motors are junk. First failure was a bearing and when it started failing, it was noisy. Eventually, the fan would not start because the motor didn't have enough torque to overcome the friction in the bad bearing.

The second fan was quiet but has NO starting torque....no unusual for fans generally, but I'll NEVER BUY another ALOHA BREEZE product again.

Sep 08, 2010 | Tower Aloha Breeze Fan

2 Answers

Aloha Breeze 16" Vintage Stand Fan Model #46051 (46052) Serial #03156: Trying to open up the case to get to the motor, to try and replace a fuse or something that's making the fan not work. I got the...


pull it up and you will see a **** in it, take a screwdriver and pry it and it will come off, I've got mine apart but don't know what to do to fix it

Sep 08, 2010 | Tower Aloha Breeze Fan

1 Answer

No water pressure


Check all valves are open, cold in bottom, pushes hot out top, and if cold at tap is doing same, take aerator off tap and see what happens. Is same thing happening at all taps?

Apr 25, 2010 | Rheem 40 Gallon FVR NATGAS Low WATER...

2 Answers

My washing machine fills up with water and then won't drain. The buttons on the top panel freeze when it gets to the spin cycle- HELP!


This is a very common probem with the main control boards if they are push buttons. If it has a selector switch, that is most likely at fault.

Oct 22, 2009 | Washing Machines

2 Answers

How do i clean my tower aloha breeze fan


you have to remove the fan housing. it is usually screwed.

Sep 10, 2009 | Tower Aloha Breeze Fan

2 Answers

Water is leaking from under washer


it a simple thing to fix look at this video it will teach U how to fix the leaking problem.
washer lick fix by kids
http://www.youtube.com/watch?v=UQ0HElQlhNA&NR=1
Please let me know if this solve your problem. Was this helpful? your rate is very important to me thank you

Aug 28, 2009 | Maytag Atlantis MAV6000 Top Load Washer

Not finding what you are looking for?
Tower Aloha Breeze Fan Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Tower Dryers Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18384 Answers

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Jay Finke
Jay Finke

Level 3 Expert

1264 Answers

Are you a Tower Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...