Sharp ar 206

U2 40 CRUM chip communication error

This means that the cartridge's sensor is miscommunicating with the copier memory thus the code U2 -40. You should clean the inner sensor connector and the toner sensor of the spilled toner by low blower. Perform this code ;# , interrupt , C, Interrupt keys in that order and press 16 then Print key and the code will be cleared.

key in 16 instead of 14 for U2 clear
Clear, Interupt, 0, Interupt, 16 then print

all action bloked code: L6-10
please healp me

ERROR CODE U2-4 COULD BE RELATED TO THE MEMORY BATTERY BEING DEAD ON TEH MAIN BOSRD IF IT IS AN OLD MACHINE SO YOU COULD CHECK THSI OR REPLACE AND TRY WITH NEW

Since this appears to be a non-US model I can only base my response on the closest US body type AR-M237.

U2-40 means the countdown (CRUM) chip in your toner cartridge either broke or went to zero. If you can put in a fresh CRUM chip in your cartridge, that's great, otherwise you'll have to replace the toner cartridge.

L4-01 means main motor lock, probably due to a brownout or otherwise missed timing. You can probably get by with a power off and on. Not sharing your copier with other devices on the same outlet will also help here.

To reset error codes, put the machine in test mode with the four-key combo: # - * - C - * ... 16-Start clears your U2 trouble, 14-Start and 17-Start clear the rest. Then hit CA and allow your copier to reboot. Good luck!

Try reset by pressing [#] [interupt] [C] [interupt] [1] [6] [start]

Error code U2 in Sharp copier AR 206 shows error or failure of toner crimp you can try to solve by replacing toner crimp

Or by reseting the error code by fallowing procedure

press c intrrupt 0 ( zero ) intrrupt contoneously after pressing all the light on control will go off then press 16 then press start switch

your prob will 100% solve.

if any more prob pl inform

U2-40 is a board error, F1-15 is finisher lift motor error.

To reset: #, interrupt, clear, interrupt. (screen should say service mode), enter 16, print, are you sure? , yes.

For the finisher error, follow above procudure, entering 14 instead of 16. if error returns, disconnect the finisher

try to cancel it by pressing: #-interrupt-C-interrupt simultaneously, then when the panel goes off input 16 then press the COPY KEY <> The machine will restart automatically. if U2 still remains.. try to replace the mainboard.