Question about Lanier Office Equipment & Supplies

1 Answer

I have a lanier 7328/7320. It reads side door open on screen. Only the door is closed. Any suggestions

Posted by on

  • americanreco Nov 15, 2010

    Its not the front door its the side door

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Lanier Expert
  • 255 Answers

How are you? This is a problem with front door switch.
Remedy

  • Place the machine on a level table and make sure all the four stands are landing freely on this table.
  • Check that the front door notch that closes the door switch is not broken and if it is replace that particular door or modify the notch.
  • Make sure the upper half of copier is well locked with the lower bottom part.
If all the above is correct, and still reads open, replace the door switch.
Good luck.

Posted on Nov 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2010 dodge grand caravan passenger sliding door unlatches but will not open automatically.closes fine. Checked wiring for breaks found none any suggestions


Maybe its connected to a control panel (left side driver door) that needs to be activated. Some door switches have a safety feature that won't allow opening automatically. Check that feature.

Jul 02, 2016 | Dodge Cars & Trucks

1 Answer

How do you record on a Lanier p-164


Turn the main power button "on" first, it is located on the skinny side of the recorder opposite of the function knob. Press eject to open the cassette door and install a microcassette tape, with the tape facing the function knob side. close the cassette door and that should load the tape and allow the tape head and pinch roller to move into place for recording or playback. pull the function knob down or push it up to record. If you go into record a red light should come "on" the top, to indicate good batteries and the record function is initiated. After recording pull the function knob all the way down to rewind the recording,when you release the button the unit goes into the play mode automatically. Make sure that the button that reads (off--- vor/fplay) is in the off position.
.

Jun 06, 2014 | Audio Players & Recorders

1 Answer

Close section properly


Its not talking about the bypass tray. Its saying the right side door isn't closed. There is a cover above the fuser that may not be closed. Open the right side door and see if you see any broken parts. If everything is closed correctly and not broken, the message will go away.

Jan 24, 2014 | Konica Minolta bizhub C250 All-In-One...

1 Answer

Emerson Microwave MW8115SS --


I would suggest you check the door switches inside the microwave oven just below the keypad, rectangular in shape. The switches are normally open or closed, set meter to ohms, unhook lead from one side and test with door open and closed. If readings are the same both ways the switch is defective. "check all switches"

Mar 19, 2012 | Emerson Fans Emerson MW8115SS Microwave...

1 Answer

Lanier 5227 scanner error


Eenter in the service mode press yellow key - 107 - red key(stop) keep press for 5 seconds,enter in the SP mode open the front door,turn OFF the main switch,wait 15 seconds close the front door,turn ON the power switch.

Jan 22, 2012 | Lanier Office Equipment & Supplies

1 Answer

Hi yes i have a Lanier LD015f. I just received the photoconductor. Hoow do you replace it?.


Hi, you should have received instructions with the photoconductor, but replacing it is pretty straightforward.
To remove the old photoconductor:
- Open the front door and the right side door. - Remove the toner hopper. - Unplug the connector going from the photoconductor into the machine. - Pull out the photoconductor.
To install the new photoconductor:

- Remove all of the tape, paper, and packing materials. - Slide the photoconductor into the slot left empty by the old one. - Attach the connector and route it behind the plastic guide. - Reinstall the toner hopper. - Close the right side door and front door.
If the machine was on when you replaced the photoconductor, it should automatically detect the new one.

Dec 01, 2010 | Lanier UNKNOWN

1 Answer

How do i empty a waste toner bottle on a lanier color copier


What kind of copier is it? On many of the Lanier color copiers, the waste toner bottle is located on the lower left side inside the front door.

Turn the copier off first. Pull the big front door open and turn the bottle with the oil to the left -- the waste toner bottle is the plastic gray tank behind that. Slide it out (carefully) and dump it in a plastic trash bag, then reinsert it.

If you have a different kind of copier, please specify the model and I'll tell you how to get to the waste toner bottle.

Feb 25, 2010 | Lanier 1205 Copier

1 Answer

Lanier MPC 3000 copier won't print faxes


Try opening up your web browser and type in the ip address of your lanier.
You should to access the facsimile function located on the left side. Once youre in the facsimile function, you should see a thumbnail view of the faxes stored in your lanier. Simply click on the faxes and delete them.

Sep 22, 2009 | Lanier Office Equipment & Supplies

1 Answer

Freezer door wont seal and stay closed


Your pushing air from the fridge part over to the freezer door when you clos it,the only thing i can suggest is make sure that the seal (which is magnetic) is clean and not falling apart,inspect it all around the door,and when closing the door i would close it gently.

Hope this helped.Let me know by rating me or
for more help go to live chat.Thanks
Len West

Feb 25, 2009 | Amana ARSE66MB Side by Side Refrigerator

3 Answers

Meter reading


2 ways to check the meter.

press the user tools button on the op panel. on the screen press counter. you can either view the counter on the screen, or press print counter, and it will give you a hard copy.

the 2nd way is to look behind the front cover, probably behind a piece of tape, on the right side, about half way down.

Nov 20, 2008 | Lanier 1205 Copier

Not finding what you are looking for?
Office Equipment & Supplies Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lanier Office Equipment & Supplies Experts

Brad Brown

Level 3 Expert

15557 Answers

George Mclaughlin

Level 2 Expert

345 Answers

Anthony Karuku

Level 2 Expert

255 Answers

Are you a Lanier Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...