Question about Car Speakers & Subwoofers

1 Answer

Seat leon Arua car radio is showing code 2000 on display

Posted by on

1 Answer

Type in code

Posted on Jul 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I have just bought a peugeot 306 registered in 2000 and when i turn the radio on the display shows 7error and does not work. the radio bar code is cl0401y0172111, any ideas to help me out, Thanks


3345 try this cannot guarantee it will work as i dont have the make and iam assuming its a clarion so i have used the clarion de encryption from the l?ast 4 numbers

Sep 21, 2011 | Car Speakers & Subwoofers

1 Answer

I need the radio code for a 2000 ML 450 bought used and code card is not available. the vin # 4JGAB72E5YA179735


Hi,
According to your requirement you have to purchase radio code or you can use car radio decoder software to decode your car radio. If you have experienced a dead battery, disconnected the factory radio harness or disconnected the battery to the vehicle then you must need radio code. Better to purchase a radio code. Before purchase determine of your radio type and do the following steps. The radio must be in LOC mode NOT in INOP mode. Turn the ignition ON. Press and hold presets buttons 2 & 3 or 1 & 4 for approximately 10 seconds. The radio display changes from LOC to a three-digit number. Write this number down. You will then have fifteen seconds max before the next step must be performed. Press the AM/FM button. The radio display changes to another three-digit number. Write this number to the right of the first one. You now have a six or four-digit number, the first three digits are from STEP 3 and the last three digits are from STEP 5. If you have a four digit number, it will show all four digits at the same time. Then purchase the code mentioning your car model and unlock the radio. You can purchase your code from radio-code.com by credit or debit card.

Sep 03, 2011 | Car Speakers & Subwoofers

1 Answer

I need the unlock code for my seat leon 20v t, aura v3 serial no. sez2z6y1752176


2236 is what my code programme is showing for a clarion but i could be wrong with the make

Jul 19, 2011 | Car Speakers & Subwoofers

1 Answer

Hi i have a 96 corsa with a grundig car 200 radio i have the code but dont no how to install the code?


Switch the ignition key ON
Press and hold AS button and the ON button at the same time
Display Shows SAFE then goes to 10 - - - - with a "Beep" from the speaker
Press Preset Button " 1 "repeatedly until the 1st Digit of your Code is displayed Press Preset Button " 2" repeatedly until the 2nd Digit of your Code is displayed Press Preset Button " 3" repeatedly until the 3rd Digit of your code is displayed Press Preset Button " 4" repeatedly until the 4th Digit of your code is displayed
If the display now shows the correct Code number then
Press Button AS and hold to Enter and if successful there should be a "Beep" from the speaker and the radio should switch on

Jul 07, 2011 | Car Speakers & Subwoofers

1 Answer

Hi, I have in my ptcruiser factory car radio. On the display is "Waiting". I know code, but when I type the code noting happens. Please can You help me? Thank You in advance.


The display should normally show CODE
WAITING on the display normally means that a wrong code (or codes) have been entered previously.
Leave the radio SWITCHED ON...UNDISTURBED for as long as it takes to automatically reset
(It should then display CODE )
If your code is incorrect then the correct one will be available from here.....CLICK HERE

Jul 03, 2011 | Car Speakers & Subwoofers

1 Answer

I hav the code ect (Blaupunkt 300 ina astra van), now need to know how to install / reset radio


Switch the ignition key ON

Press and hold AS button * and the ON button at the same time

Display Shows SAFE then goes to 10 - - - - with a "Beep" from the speaker

Press Preset Button " 1 "repeatedly until the 1st Digit of your Code is displayed
Press Preset Button " 2" repeatedly until the 2nd Digit of your Code is displayed
Press Preset Button " 3" repeatedly until the 3rd Digit of your code is displayed
Press Preset Button " 4" repeatedly until the 4th Digit of your code is displayed

If the display now shows the correct Code number then

Press Button AS and hold to Enter and if successful there should be a "Beep" from the speaker and the radio should switch on

Jan 21, 2011 | Blaupunkt Car Speakers & Subwoofers

1 Answer

GM Radio Locked but will not display codes by pressing 1&4 or 2&3


Does your GM car or truck Radio display LOC and does not turn on? Chevrolet, Buick, Pontiac, GMC, Cadillac, Oldsmobile vehicles used a theft system to lock the radio when power is lost. This system was used from the ealy 1990's to the early 2000's.
jQuery('.intro .thumbnail').each(function(i,e){ jQuery(e).find('img').one('error',function(){ jQuery(e).remove(); }); });
Instructions:
  1. If your radio displays the word LOC, you can retrieve a set of factory numbers in the radio that enable you to get a backup unlock code. If the radio says INOP, you will have to leave the key in the "ON" position, or let the car run for at least 1 hour before you attempt any unlock procedure. INOP means a secondary theft lock due to too many false attempts to unlock the radio.
  2. Looking at the face of your GM Delco radio, hold down the preset buttons 1 & 4 OR 2 & 3 (Depending on year and model) for approximately 10 seconds or until a set of 2 or 3 numbers comes up on the display. Write the numbers down.
  3. Next press the AM / FM button. A new set of 3 numbers will now show. Write these numbers down. You will then need to call a 1-800 phone number with these numbers to get the unlock code. There are many sites on the internet that can get it for you- for a small fee. Or, try calling your local GM Dealer and ask for them to do it. Many times they will do it for free. It only takes a minute.
  4. Once you have the unlock code, enter it by pressing the MIN button until the display shows the last 2 digits of the unlock code, then press the HR button until the first 2 numbers or shown. Then press the AM / FM button to enter the code. The radio will now display SEC, and normal function is restored.
Also, its possible that you need RESET your GM Radio; this is the procedure: While performing maintenance on your car, you may disconnect the radio from the battery in your GM vehicle. GM cars contain Delco radios that are protected by Theftlock, which locks the radio after it has been disconnected from a power source. Iit can only be reset and unlocked with a car-specific security code. Identifying the security code for your GM vehicle is the only way to reset the car radio and disable the Theftlock protection device. jQuery('.intro .thumbnail').each(function(i,e){ jQuery(e).find('img').one('error',function(){ jQuery(e).remove(); }); });
Instructions:
  1. Turn on your car. Your Delco radio will show "LOC" in the LED display.
  2. Press and hold down both the second and third preset buttons. Hold these buttons down for at least six seconds.
  3. Write down the two- or three-digit code that appears in the LED display.
  4. Press the AM/FM button on the radio.
  5. Write down the next two- or three-digit code that appears in the LED display. You should be left with either a four- or six-digit number. Turn off your car.
  6. Call the Delco radio automated customer support line at 1-800-537-5140.
  7. Press "1" and then press the pound sign. The automated voice should respond "Invalid code, try again."
  8. Enter the number 139010 into your phone and then press the "*" sign.
  9. Enter the four- or six-digit number you wrote down from Steps 3 and 5, and then press the "*" button.
  10. Write down the four-digit code given by the automated voice.
  11. Turn on your car. Enter the Delco unlock code using the procedure outlined by your GM owner's manual. Normally, the unlock code is entered with the "HR" and "MN" buttons on your radio.
  12. Press the AM/FM button. If you have entered the code correctly, your LED display will read "SEC" and the radio will be unlocked.

Hope this help.

Mar 18, 2010 | Car Speakers & Subwoofers

1 Answer

Need 1998 montero sport radio reset code


GETTING THE RADIO SERIAL NUMBER: <BR>
2000 - Carefully take the front panel off that surrounds the radio and temperature buttons, it will snap straight out. Wiggle the radio out about two inches, it is a tight fit. Get the serial number off the radio. It is on a sticker on the top, left side. Call a Mitsubishi dealer with the serial number. They will want proof of ownership, so have the title ready. After putting in the four digit serial number, hit the cd button and that enters it.The code is also written on an antitheft card that comes with the car and may be written in the owners manual in one of the back pages.
<BR> 1999 - Carefully remove the cup holder by pulling it out, then you will see the sticker with the radio serial number.
<BR> Other Years - I don't know an easy way to get the radio serial number, find a radio install savy person and ask them to help you. My dealership said they would do it for me and charge me for 30-60 mins worth of labor.. (At $75/hour) <BR> <BR>
RADIO SAYS "OFF" OR "LOCK": <BR>
Leave the "off" display on for 1 hour uninterupted, then it will automatically reset back to UNLOCK CODE.
<BR> When you turn it back on again after that time has passed it will ask for "code". <BR> <BR>
RADIO SAYS "UNLOCK CODE:" <BR>
Call your local MItsubishi dealership and ask for the service department.
<BR>They have a computer program where they punch in the serial number from your radio (you have to supply the number) and it will tell them the UNLOCK CODE for your radio. My dealership offered to give it to me free over the phone, if I knew my radio serial number. Enter the code using the buttons on your radio. And write the code down, this will show up everytime your radio looses connection to its power source - the car battery.

May 27, 2008 | Car Speakers & Subwoofers

Not finding what you are looking for?
Car Speakers & Subwoofers Logo

Related Topics:

385 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Speakers & Subwoofers Experts

xxxxxx xxx

Level 3 Expert

4706 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Car Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...