Question about Whirlpool Ovens

3 Answers

The clock keeps flashing and none of the knobs will respond. The oven will not turn on

Posted by on

  • 1 more comment 
  • betterob Nov 12, 2010

    Thank you. The model No isRF395PXXN2

  • betterob Nov 12, 2010

    The diagram is too small. Howeverplease give me the name of the part, so that I may replace it if possible.

  • betterob Nov 13, 2010

    The model is RF395PXXN2

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,891 Answers

When the beeping starts this lets you know that the E O C clock has determined a problem .. likt over heating . or no lock up on door . but a problem has come up . so it has shut the oven down . ther is some times a code in the display and it will tell what is going on . you can try to turn power off and then on in five min and this will reset the memory .. if the problem comes back most common is the sensor and then the clock it self . mm hope this helps . feed back pls . and thanks for using fix ya .

Posted on Nov 16, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,566 Answers

Hello there,
Could you please tell me the model of your oven?

Posted on Nov 13, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,323 Answers

Hi

Flashing clock means that the issue is with the Electronic Range control that is bad. However, please post back with the model# no so that I can help you.

Daniel

Posted on Nov 12, 2010

  • Daniel Scott
    Daniel Scott Nov 12, 2010

    Please check this picture:




    part#13 is what I think has gone bad.

  • Daniel Scott
    Daniel Scott Nov 13, 2010

    It is the control that should be replaced.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Naff U1721 bottom oven does not turn on. Top oven works o.k. The light to the left of the control knob and inside the oven does not come on. Could you tell me what the problem might be?


clock must be set for bottom oven to work not flashing 00.00 if clock set check its not on auto setting if thats ok then clock has failed will need replacement.

Jan 05, 2017 | Neff Ovens

3 Answers

Cannot turn the oven on


Too vague need model number an what steps you use to turn on

Feb 17, 2015 | Whirlpool Ovens

1 Answer

Set clock on an old thermador double convection oven


Turn the main knob counter clock wise until the display reads "clock", then turn the same knob clockwise to set the time. When done, push the select button.

Feb 25, 2012 | Thermador SMW272 Electric Double Oven

3 Answers

How do I set the clock


Set the clock by following these steps: a). Touch TIME pad. b). Turn rotary knob clockwise until CLOCK appears. c). Touch TIME pad. d). Turn rotary knob in either direction. The time displayed will change in 10-minute increments and indicate AM or PM. Turn the knob in the opposite direction and the display will change in one-minute increments. e). Touch TIME pad. The clock is now set. in some units there is button instead of knob in that case the clock indicating button has to be pressed . This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya

Feb 06, 2010 | Bosch Appliances 27 in. Wall Oven Electric...

1 Answer

My oven wont work afte a power cut its flashing oo:00 auto and I dont have a manual


you have 2 buttons one pops out for adjustment the other is only a push button push the left hand one repeatedly till a red clock symbol shows at top of clock then turn right hand knob to set time wait a few seconds and clock will set itself.

Nov 16, 2009 | Neff B1421 Electric Single Oven

3 Answers

Clock flashing OOO continously


My son came along and managed to get the clock operating once more by just pressing one of the buttons and turning the knob to set the time. Many thanks for your contact. It was much appreciated. I shall know what to do in case this ever happens again.
Regards, Mary Yorkston

Aug 29, 2009 | Neff B1421 Electric Single Oven

1 Answer

How do i turn on the oven?


First set the clock if you cant do that just press buttons till the numbers stop flashing the turn the knob with pictures to one that looks like a fan in a box that should be fan forced option the select the tempreture with the other knob

hope it helps

Aug 17, 2009 | Fisher and Paykel OB24SDPX1 Electric...

2 Answers

Kitchenaid superba 27 double oven clock - can't change the time!


I went to the website:

http://shared.whirlpoolcorp.com/assets/pdfs/literature/Use%20and%20Care%20Guide%20-%203177060.pdf

http://www.kitchenaid.com/custserv/service.jsp
from page 8
Turn the knob to the left until a tone is heard and "time" appears in the display window. The previously set time will appear in the display window.

Continue turning the time knob in either direction until the correct time of day appears in the display window

Press the START button to begin clock operation

Nov 17, 2008 | Ovens

1 Answer

Neff series 1 oven


press the two arrow buttons in at the same time as turning the pop out knob

Aug 04, 2008 | Neff B1421 Electric Single Oven

2 Answers

Tricity bendix double oven


My oven's fan is working but no heat what so ever what shall i do

May 07, 2008 | Ovens

Not finding what you are looking for?
Ovens Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Ovens Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

 Fix Your Board
Fix Your Board

Level 3 Expert

310 Answers

ashburton

Level 3 Expert

417 Answers

Are you a Whirlpool Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...