Wiring diagram for hobart WM-5H - Hobart Dishwashers

Lots in this link

https://www.google.com/search?q=Hobart+A200+1988+Wiring+Diagram&rlz=1C1QJDB_enCA643CA644&sxsrf=AOaemvJzCQJTHWA7UW7hDdhBzAkW3pesxQ:1635703599310&source=lnms&tbm=isch&sa=X&ved=2ahUKEwiI6_nfnvXzAhX9l2oFHS9OAdsQ_AUoAXoECAEQAw&biw=1920&bih=937&dpr=1

This is the best one

https://www.oldhobartmixerparts.com/a200-wiring-diagram.html

..

Hobart 4822 Instruction Manual


I came across this , Hope it Help's !

Tom

clogged tubes,and/or locked pump motor,need to ceck pump (on the very base of the device) for clearence and normal function,it can get a little tricky,u must have a minimal experience in mounting dismounting
most dish washers i have cleaned had small pieces of boness stucked in the pump,of course i got some that were needed to replace pumps or other switch,relay,board...
I got lucky with others,after removing the grids on the bottom I could stick a couper wire in the pumps entrance and release the rotor without having to dismount the device
best regards

Take a look at:

http://www.diversewebsitesolutions.com.au/hf/manuals/FOOD%20PREP/MIXERS/CURRENT%202011%20MIXERS/HOBART%20HL600/HOBART%20HL600%20MIXER%20TECHNICAL%20AND%20SERVICE%20INFORMATION/

How can I get a wiring diagram for a Hobart AM15VL dishwasher

looking for a wiring diagram for hobart hr7 rotisserie oven

The WM-1D does not have any internal heating devices. You have to supply the machine with the proper water temp. It has two fill valves, one for wash and one for rinse. It should have 150F supplied to the wash fill valve and 180F to the rinse fill valve.

The lid to control box has diagram inside, the heat kw is in the metal ID plate on right end of top of control box

I can tell you where the wires need to go.What are you trying to hook up on the dishwasher?