It only prints on the left side of the paper. The print fades and then there is nothing on the right hand side. It doesn't matter what you print or from what program, only about 2" prints down the left side of the paper.

Your toner cartridge may be the culprit.
Take the cartridge out and shake sideways and up/down. Reinstall it and try again.
If it's still printing faded side, replace the cartridge.

Okay, the paperfeed at the top, on the left hand side there is a grey slide, (right in the printer) to hold the paper in place. Use it to keep the paper straight! It seems that if the paper goes in straight, the whole page is printed, if it doesn't it messes up the page.

Worked for other people having trouble with Epson Printers

Have the latest available printer drivers been installed?

Print the "supplies status" page.
Replace any cartridges that are low, Replace the imaging drum if it is low or empty.

What has wrong is the toner cartridge holder has jumped a tooth and thats what is causing it. It is a easy fix but very hard to tell you over fixya. Steven 818-888-0006

Have you check the teflon at the heater? have you clean the reflector of laser? Try that.

Dell printers are junk. But you have put a lot of money into this thing. Check the alignment of the black drum, could be that something is keeping if off track a little bit.

i want to download the driver softwere of samsung clp-300 series vista ultimate supported

Hello I have sorted the growling sound out with a shot of WD40 lube ,but have not sorted out wht the cyan does not print clearly any advice would be helpfull

This type of printing defect is normally caused by 1 of a few problems - the easier one first:

1. Toner cartridges sometimes do not have the toner evenly distributed - close the toner cartridge and inspect the hopper right below it for even distribution of toner.

The harder ones:

2. This type of defect can also be caused by dirty charging section - for the drum to pick up the toner it must be charged electrically prior to exposure - if the charge grid is not clean then it will not give the drum an even charge - not sure were this is in this printer yet - looks like it comes as part of the drum kit so this should not be causing this issue.

3. The last and most difficult to check is paper alignment with the drum - is the paper contacting the drum evenly - look for possible problems in the paper path with the drum unit removed - look for something uneven around the area were the paper contacts the drum