Question about Kal Equipment Battery Tester - KAL Equipment

Open Question

We have a kal 8300 battery tester will not power up when we hook it up

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

gotgeek2
  • 565 Answers

SOURCE: i need an instruction manual for a kal model 4260

I'll tell ya, it sure took some digging to find that one. Evidently KAL Equipment was acquired by Actron.
http://www.actron.com/media/usermanuals/KAL4260_0002-000-2374%20PW_Battery%20Load%20Tester_MNL_Eng.pdf

Posted on Feb 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i hook up monitors to peavey 8300 mixer


Make sure main monitor switch is pressed in, look at back of unit, the speaker jack labeled main/monitor is now monitor output, you may use 2 8 ohm speakers, use controls on front labeled monitors.

Jun 27, 2012 | Peavey XR 8300 8 Channel Powered Mixer

3 Answers

My car is showing no signs of any electrical power


Check the battery cables from the battery to the main fuse block and to the starter and all the grounds. Have you tested the battery to make sure it has a charge?

Apr 05, 2011 | 2007 Chevrolet Monte Carlo

1 Answer

1997 gmc sierra battery wont stay charged. Alternator and battery have been tested. What else could it be...fuseible link. If so where do I find it?


I suggest you hook up 12 V digital multitester to the battery running & get your voltage. Next stop the truck & get the voltage leaving it connected & you should see the voltage steadily dropping. Then, take off the Negative cable & hook up the tester again to the 2 post of the battery & see if the voltage drops as before, or has stabilized. That will tell you if the truck is draining the battery for sure of if you have a bad cell. If it is the truck, you will need to go through troubleshooting the entire vehicle by eliiminating all use of current and gradually hooking things back up. IE: disconnect main fuses/breakers & see what happens on the tester. Then start connecting 1 item at a time & see what is requiring power or if you have a short. You should eventually find the culprit even if you have to remove fuses and test each time. An additional tester that test amperes without penetrating the wiring is helpful in finding the drain. Normally in the auto-parts stores. I just lay mine over the wiring & follow the voltage until I find the wiring leading to the one using the power or that is shorted. Good Luck.

Jan 27, 2010 | 1997 GMC Sierra

1 Answer

I need an instruction manual for a kal model 4260 battery tester.


I'll tell ya, it sure took some digging to find that one. Evidently KAL Equipment was acquired by Actron.
http://www.actron.com/media/usermanuals/KAL4260_0002-000-2374%20PW_Battery%20Load%20Tester_MNL_Eng.pdf

Feb 20, 2009 | Kal Equipment Battery Tester - KAL...

1 Answer

Powering Issues


Try removing the battery from the phone if it does not power on after placing battery in the phone. press the red phone button or the green phone button. Removing battery and making sure your all cards are seated properly in the phone should do the trick

Jan 17, 2009 | AT&T Blackberry Curve 8300 Smartphone

1 Answer

Sanyo SCP-8300


I'd suggest a new battery, if money is no problem but otherwise, if you have a volt-meter of some kind, you could read the voltage output of the charger and compare that to what it says it should be in the input-output list usually printed on the underside. If it's fine, I'd try carefully cleaning the phone's battery and charger contacts with a small amount of rubbing alchohol and some cotton swabs or tooth-picks lightly wrapped in toilet or tissue paper. If it still refuses to work, you could see if a sales-clerk at your local phone store would let you try a new battery to see if it would work. Otherwise, you could attempt internal repair/cleaning like I outlined here- keys won't work on sanyo mm 8300 phone.
Hope this helps, TechnoWolfy.

Oct 09, 2007 | Sanyo MM-8300

Not finding what you are looking for?
Kal Equipment Battery Tester - KAL Equipment Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kal Equipment Measuring Tools & Sensors Experts

Vuk B

Level 3 Expert

678 Answers

Brad Brown

Level 3 Expert

15441 Answers

Tom Chichester

Level 3 Expert

33272 Answers

Are you a Kal Equipment Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...