Question about KitchenAid Microwave Ovens

1 Answer

I have a Kitchenaid Dishwasher model kuds01fkss0, serial # fl3202898. The machine will start and run on the wash cycle continuously until the cancel button is pushed. I ordered the control card #8528172 and received the replacement card for this assembly, but on connector #1 the Y circuit has been removed and the washer will only run in wash for 10 min and the machine goes dead. Is their a connection mod to used the replacement card or is this machine "toast" Thanks Shep Beyland

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 19 Answers

Posted on May 21, 2017

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

vetteman3002
  • 2299 Answers

SOURCE: whirlpool dishwasher, quiet partner 1,

If you can tell what cycle it is in, then it will be a lot easier to troubleshoot. I would suggest calling the 800 number in the manual and making Whirlpool pay for the repair. If the dishwasher is only 3 months old, then they will send a tech out to fix the dishwasher free of charge.

Posted on Jan 15, 2011

richroth
  • 9472 Answers

SOURCE: whirlpool dishwasher, quiet partner 1,

Based on your symptom and details there could be something jammed in the chopper assembly or it could be the wash motor bearings causing it to stop the wash cycle and drain. I added some information and instructions in the image below if you would like to check the chopper blade area for any hard objects. You may have to replace the wash pump motor if no objects in the chopper blade. NOTE: Disconnect the dishwasher from the power supply if you're going to have to remove and replace the wash motor.
richroth_64.jpg richroth_65.jpg

Posted on Jan 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Kitchenaid microwave model YKCMS1555RSS-1 continues to run. The microwave will only stop once the door is open or the unit is unplugged. Any ideas what this could be?


One of your three door switches is bad. They are cheap. replace them all. Careful some are normally open and some are normally closed. Don't get them confused or you will get other symptoms like a blown fuse

Dec 30, 2014 | KitchenAid Microwave Ovens

1 Answer

Khhc2090s trouble


The sensor errors are probably just from opening the door and interrupting the sensor cook cycle.

By the way, you should always press "Stop" before opening the door of a running microwave. Otherwise, the door switches will prematurely fail.

I would first check the door switches and their mounts. See this help file.

You can usually find helpful exploded view diagrams and order parts by entering your full model number here.

There should be a "mini-manual" (tech sheet) hidden inside the unit behind the control panel or hidden on the left side behind the grille, which is very helpful when troubleshooting, testing, and locating components.

12_3_2011_7_32_02_pm.jpg

You can also download manuals, installations info, and parts lists here.

dee77f7.jpgWe're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Nov 25, 2011 | KitchenAid Microwave Ovens

1 Answer

Ignitors continue to pop altho all four knobs are in off position Kitchenaid gas stove top Model #KGCT305X Serial #XB2806974 ir X52606974


Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range Repair Burners Keep on Clicking
heatman101

Apr 21, 2011 | Microwave Ovens

1 Answer

Model KCMS1555R KitchenAid Microwave Oven turntable continues to operate even when the door is open. It seems to work otherwise. I disconnected it from the power hopping it would reset but that did not...


This is an extremely dangerous situation, if the microwave oven is running with the door open it means the safety interlock switches are not working the way they were designed to, and needs to be checked out for safety reasons. I recommend unplugging the device and not use it until it has been checked by a qualified technician.

Mar 27, 2011 | KitchenAid KCMS1555RSS Stainless Steel...

2 Answers

I need to reset my Kenmore Elite dishwasher but i don't know how.


Hello,

follow the below instructions:

Unlock your Kenmore dishwasher control panel by pressing and holding the "Heated Dry" button for four seconds.

Press a series of four buttons in quick succession. Press "Heated Dry," "Normal Wash," "Heated Dry" and "Normal Wash" to instruct your Kenmore dishwasher to run a short diagnostic test

Wait for two minutes while your Kenmore dishwasher runs its diagnostic test.

Press the "Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel and stop the "Clean" light from blinking repeatedly.
Good luck.

Jul 14, 2010 | Microwave Ovens

2 Answers

Kitchen aid microwave is locked


Touch and hold cancel/off button until unlock appears on the display.

Jun 21, 2010 | KitchenAid KHMS155LSS 1000 Watts Microwave...

1 Answer

KitchenAid kemc308kss0 Micro/Oven Combo Microwave: At the end of any cycle there is a four-tone beep that will continue to beep until KINGDOM COME until you either a. open the door b. press cancel. That is...


From page 7 of your owner's manual:

All Tones (combination oven models only)

All of the above tones are preset on, but can be turned off.
To Turn Off/On: Touch and hold STOP TIME for 5 seconds. A
tone will sound and “Snd oFF” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd on.”

Tone Volume

The volume is preset at high, but can be changed to low.

To Change: Touch and hold the number pad “7” for 5 seconds. A
tone will sound and “Snd Lo” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd HI.”

REMINDER TONES

The Timer and Timed Cooking reminder tones are preset on, but
can be turned off. Reminder tones do not include end-of-cycle
tones. On combination oven models, if “All Tones” have been
turned off, the reminder tones cannot be independently turned
on.

Timer

To Turn Tones Off/On: Touch and hold TIMER SET • START until
a tone sounds. Repeat to turn back on.

Timed Cooking (combination oven models only)

To Turn Tones Off/On: Touch and hold COOK TIME until a tone
sounds and the lower oven display returns to inactive mode
(blank). Repeat to turn back on.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Apr 26, 2010 | KitchenAid Microwave Ovens

1 Answer

F2 Message Code


good day,
hope this link below will solve your problem.

kitchen appliances

Jul 03, 2009 | KitchenAid KHMS155L Microwave Oven

2 Answers

KitchenAid KCMC155J


Sounds like a classic bad door switch or switch holder. If you or a friend decide to work on it, we have *critical* safety info, info on door switch testing and replacement, and oven disassembly info at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk You can find helpful exploded view diagrams and order parts by entering your base model number (without the suffix) here: http://tinyurl.com/gv383

Mar 11, 2007 | KitchenAid KCMC155J Convection/Microwave...

2 Answers

Crisp display


yes, it does indicates there is a bigger problem It has run a self- checking program and displayed the error before calling help see in this model page there is a manual of the oven, check last pages if they help u if no still there are instructions what to do and who to connect read it well before calling it will save u more then a couple of $$$ good luck windman

Jan 17, 2006 | KitchenAid KBMC140H Convection Microwave...

Not finding what you are looking for?
Microwave Ovens Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top KitchenAid Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

9047 Answers

Stu Ungar

Level 2 Expert

52 Answers

Darial Jr Lasaria
Darial Jr Lasaria

Level 3 Expert

378 Answers

Are you a KitchenAid Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...