Question about Whirlpool Safety Bath Walk In Bathtub - Stretch Without

Open Question

We have a 7 year old Aqua glass Model 567236BC-WH W/P. The motor does not work. Aqua Glass customer service said it was out of warranty and to buy a new tub! Actually they were very rude. The tub is built in with a ceramic tile surround. It would cost thousands! Do you have a source for a replacement motor?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 374 Answers

SOURCE: bath tub installation

Okay lets start with the most obvious: Check all studs to ensure they are plumb. I am assuming all sheetrock and tile has been removed. if so measure the distances from the bottom plates on the end walls. it should be 60 inches in the clear. measure the height of the tub from the edge of the skirt that contact the floor to the top of the skirt then measure this distance off on the front and rear studs on both end walls and mark it off. Now measure to see that you still have 60 inches in the clear at both the front and rear locations. Now measure the tub as well to ensure it wasn't mis-manufactured. If all your measurements come in at 60 inches you should be able to bring the tub in and slide it in as it is when it is finished. If you find out that you have less than 60 inches in the clear for the tub you can use a drill and jigsaw to remove additional wood from the studs to get it to drop in. Once in you can fir the wall back out to the original dimension and sheetrock and tile. One thing you need to remember is that you may need to take wood out of bot ends to get the drain to rough in correctly.
I hope this helps you out and thanks for using Fix Ya.

Posted on Oct 16, 2008

  • 123 Answers

SOURCE: aqua glass whirlpool tub leaks. looking for

To my knowledge there are no closure caps for your tub; you can however purchase new jets with new seals if the tub is leaking through the jets.

Posted on Sep 01, 2009

  • 10917 Answers

SOURCE: I bought a house with aqua glass whirlpool tub (14

will have to remove access panel or make one the motor /pump assembly is mounted to the tub test for power to the switch and pump the numbers u are looking for are their by pump

Posted on May 04, 2010

uspartscente
  • 717 Answers

SOURCE: My Aqua Glass Whirlpool tub

Your motor is shot. you need a new pump. If it comes on and you can hear a hum then it is bad. If you can get us a model number of the pump we can recommend a replacement model for you.

US Parts Center

Posted on Jan 13, 2011

uspartscente
  • 717 Answers

SOURCE: my american standard jacuzzi tub

check the air tubing coming off the back of the motor. that tubing should connect from the air switch on the motor to the bottom of the air button on the top of your tub.
if it is not connected then it will never turn on.

Posted on Feb 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need model number of aqua glass acrylic shower, i have the serial number, can it tell me model number?


Try MFG website, or their customer service email or
for an Owner's manual try manualslib.com

Apr 10, 2015 | Home

1 Answer

Can't find a pump for Aqua Glass model 566042BC


What model of pump? Pumps are changed and identified by the model and brand name of the pump, NOT the model number of the bath tub.

Rod

US Parts Center

888-521-6183

Mar 22, 2013 | Home

1 Answer

I have an Aqua Glass Jaccuzzi that I haven't used in 10 years. The last time it was used it worked perfectly. Now I can't turn it on at all. I don't remember is just the round dial that


Check the circuit breaker and make sure you have power to the pump.
If you have power to the pump and it is not operational when the tub is full of water and you are in it then I would say you have a serious problem.
Most all of the older control that Aquaglass has used in the past have been discontinued.
You may want to visit this link and identify your control before you begin t trouble shoot your system.

Rod
US Parts Center
888-521-6183

Feb 27, 2013 | Whirlpool Safety Bath Walk In Bathtub -...

1 Answer

Cracked glass top stove. is it covered under a waranty? it is maybe 4 years old. brought at sears its a whirlpool stove.


whirlpool offers a five year warranty on glass cooktops for thermal damage only not for customer mishaps so call a certified repair place and they can get you a new cooktop if you tell them that it is thermal cracking

Sep 12, 2009 | Cooktops

2 Answers

GE Microwave/Convection Oven - Door Glass Just Exploded!!!


This happened to us 3 weeks ago with our 3 year old Kitchenaid microwave. Several hours after its last use it just shattered. In doing research I discovered that this has also happend with GE microwaves, all 3 years old. The cause seems to have been a batch of defective glass supplied by a third party. Whirlpool was very quick to cover the cost of the replacement, even though our microwave was out of warrantee.

Aug 27, 2009 | GE JEB1095 Convection/Microwave Oven

1 Answer

Replaceing glass top on a stove


The top can be replaced but it is expensive. Your range is less than a year old call a local servicer to see if there may be warranty available to cover this problem it may not cost you anything. Good luck.

Jan 15, 2009 | GE JBP64 CleanDesign Electric Kitchen...

1 Answer

Where do i find replacement glass tops for my hotpoint stove? How much do they run????? thanks for the info The glass top has burned, and i cannot remove to burns, can i replace the glass top? and how...


hello Chris700,
welcome.

1.What is the model #
2. How old is the range?

If the range is 6 years old or more it may not be worth spending to much money on it.
Bless you huuum


Here is an article I just read about this matter!


Repair or replace?

When to pull the plug on your old refrigerator

It nearly always makes sense to undertake simple do-it-yourself repairs,
such as replacing a gasket on a refrigerator or a freezer.

Typically, you'll also find a troubleshooting section for more-serious problems
in the owner's manual.

Should you pay for a repair or buy a new model?
The answer depends mostly on the age of your refrigerator,
how much you bought it for,and the cost of the repair.

Follow these guidelines:

When a repair makes sense.

If your refrigerator is under warranty or less than four years old (three years for top-freezers),
paying for a repair makes sense.
Note that refrigerators under warranty might require service from a factory-authorized technician;
readers have found them on a par with independent repairers.

When a repair might be a wise choice.

If your refrigerator is out of warranty and is four to seven years old,
it might make sense to pay for a repair. Customers generally pay $100 to $200 for a repair.
But you might want to buy a new model even at this stage,
given that today's models are quieter and have added features.
Higher energy efficiency is another plus: Energy Star-qualified models made after April 28, 2008,
are 43 percent more efficient than conventional models built before 2001 and 56 percent
more efficient than those built before 1993.

When it pays to replace.

The repair costs more than half the price of a comparable new refrigerator.
Data also shows that it doesn't pay to fix a less-expensive top-freezer refrigerator
six or more years old or a bottom-freezer or side-by-side eight or more years old.

Thanks to better recycling programs, less than 10 percent
of a refrigerator you replace is likely to end up in a landfill.


Thanks for giving me the opportunity to help!
Please do not for get to give a rating before you sign off!
Thank You, HUUUM

Sep 18, 2008 | Kenmore 40494 / 40495 / 40499 Electric...

1 Answer

Electric Glass top range broken


Hello leebenchang9 ,
Welcome to fixya.
I'm Huuum and happy to assist you

You can find a fixya repair service near you by finding this section on our site and entering your zip code! The service arrangement can give you a price!
How old is your range?


Please do not forget to leave a rating.
Thank you Huuum

Find Kitchen Range Repairman Near You: Browse the Repair Directory


Here is an interesting report I just read!
Repair or replace?

When to pull the plug on your old range



Typically, you'll also find a troubleshooting section for more-serious problems
in the owner's manual.

Should you pay for a repair or buy a new model?
The answer depends mostly on the age of your range,
how much you bought it for,and the cost of the repair.

Follow these guidelines:

When a repair makes sense.

If your range is under warranty or less than four years old ,
paying for a repair makes sense.
Note that ranges under warranty might require service from a factory-authorized technician;
readers have found them on a par with independent repairers.

When a repair might be a wise choice.

If your ranger is out of warranty and is four to seven years old,
it might make sense to pay for a repair. Customers generally pay $100 to $200 for a repair.
But you might want to buy a new model even at this stage,
given that today's models have added features.
Higher energy efficiency is another plus: Energy Star-qualified models made after April 28, 2008,
are 43 percent more efficient than conventional models built before 2001 and 56 percent
more efficient than those built before 1993.

When it pays to replace.

The repair costs more than half the price of a comparable new range.
Data also shows that it doesn't pay to fix a less-expensive range
eight or more years old.

Thanks to better recycling programs, less than 10 percent
of ranges you replace are likely to end up in a landfill.


Thanks for giving me the opportunity to help!
Please do not for get to give a rating before you sign off!
Thank You, HUUUM

Jul 29, 2008 | Maytag MER5775Q Electric Kitchen Range

2 Answers

TEC grill


I have a TEC Pattio II. I have owned the grill for almost 10 years and TEC grills have a ten year warranty on many of the parts including the burners. The burners on my grill have a ceramic inserts. The pop and loud whooshing noises indicate the ceramic insert or the seal on the burner is "cracked". I have replaced both of the inserts and burners on my grill once about 5 years ago under warranty. I have one burner now that will not stay burning and I contacted TEC today regarding the problem, and I will replace the ceramic insert only under warranty. .

The newest TEC grills like yours have the TEC Radiant Glass Infra-red Cooking System with stainless steel burners with glass surfaces. Confirm with TEC customer service that your grill has has this burner system and not the ceramic one. I assumed this burner system had eliminated the problem of the burners going out with a loud boom.

YOUR ONLY OPTION IS TO CONTACT THE CUSTOMER SERVICE GROUP AT TEC. THE TELEPHONE NUMBER IS 1-800-331-0097. TEC IS LOCATED IN COLUMBIA SC. TEC HAS A USEFUL WEBSITE. I WOULD NOT LET TEC OFF THE HOOK IF YOUR GRILL IS LESS THAN TEN YEARS OLD.

I noticed the skills of the customer service reps are lacking. You may need to talk with the manager. I love my grill and would not have any other brand or type. It is imperative to follow the cleaning instructions in you user manual.

May 14, 2007 | Tec RadiantWave Grill

Not finding what you are looking for?
Whirlpool Safety Bath Walk In Bathtub - Stretch Without Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Home Experts

Donni Steen

Level 3 Expert

659 Answers

john h

Level 3 Expert

10917 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Whirlpool Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...