Unable to create l2trace server process, socket_open() failed

The setup for your server connections is wrong.

The combination of port 465 and no SSL will never work. You must either enable SSL with port 465, or else try a non-SSL port like 587 or 25. What mail program are you using?

you are using a trunicated (packages missing) server download.
get an offical copy of Ubuntu linux from on-disk.com and, your troubles will be over;

Solution : Make Sure the SMTP (Mail) Server is an Open Relay Server or Uses POP-Before-SMTP Authentication The mail server being used must be an Open Relay server or use POP before SMTP authentication. If the mail server being used requires SMTP authentication, the scan to e-mail process will fail. The WorkCentre is unable to access the mail server when SMTP authentication is required. Contact your Internet Service Provider (ISP) or System Administrator for additional information.
NOTE: The WorkCentre was designed to send e-mail through internal corporate mail servers. In most cases, if using your Internet Service Provider (ISP) mail server, the scan to e-mail process will fail because most ISP mail servers require SMTP authentication to send mail. Contact your ISP for additional information.

Hi If a page does not return within a few minutes, many users perceive that a problem has occurred and stop the process. Therefore, design your server processes to return data within 5 minutes so that users do not have to wait for a long time.

You can usually break down long processes into smaller pieces. Or, the server can return status data to update users about the process. In addition, you can create a long server process with a messages-based or asynchronous approach so that it returns immediately to the client after the job is submitted and notifies users when the long process is finished.

This message indicates a hardware failure. Reboot and watch the POST and ASIC tests to see exactly what component is failing. If this device is under SmartNET contract with Cisco, contact them for replacement. If not, you will most likely need to purchase a replacement switch.

Sounds like you may need to reload the IOS

Try setting the date.

You need to either use a Domain Account if you are using Windows authentication or you need to use SQL server authentication.
The reason for this is because the user account that you are using only exists on the machine that you are on not on the machine that you will be replicating to.