Question about Sony Cybershot DSC-S950 Digital Camera

1 Answer

It fell on the tile face down on the lens, and the lens is stuck. When i turn it on, it says turn off and on again. Please help!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,831 Answers

Hello

The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the probability is that you will have to get it fixed by a professional.

Use these at own risk as it may further damage the camera.

Firstly , try connecting your ac adapter or usb cable.

Try holding the shutter button while switching on the camera.

Look at the lens , and if some of the lens 'circles' is misaligned or not concentric then try wiggling it (while holding camera lens down).

Try gently pushing or pulling the lens when it extends but this is risky as it may cause the lens barrel to slip out of its guidance system.

Another way to do this is to place the camera lens down on a hard surface and then power it up. Be sure to use a soft cloth or something similar as to not scratch your lens or casing. Let the lens push the camera up and down a few times and sometimes the little resistance provided by the camera is enough to get things going again.

Try hitting your camera near the lens on the body with the soft tissue on the palm of your hand.

Other than that , I would take the camera to a repair centre for a evaluation to see if it would cost more to repair than to replace the camera.

If it is still under warranty I would suggest you take it in before trying any of these steps and remove any off-brand batteries or accessories as some stores are really fussy about warranty repairs on camera's with non-brand accessories.

You can also have a look at THIS link.

Hope the advise is useful. please do not hesitate to let me know if you need any further assistance. Also, please be so kind to let me know if you found this helpful.

Regards
Andrea

Posted on Feb 11, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony cybershot camera fell and lens is stuck


The lens may be out of position, or there could be dirt/dust in the lens mechanism. You could try some of the following suggestions:

1: Switch on the camera while you hold the shutter button and connect it to the AC adapter or to the USB cable at the same time.
2: Now by default the lens should get properly aligned if not try to twist them slightly by holding down the camera lens with soft hands.
3: Just push and pull the lens slightly as it extends automatically.
4: Now when the lens is in the hard surface power on your camera.
5: Try to hit the camera softly beside the lens which might solve the issue.

Sep 07, 2014 | Cameras

2 Answers

F-stop stuck on F00


aperture stuck at f00.... 50mm 1.8... please help!!!

Apr 22, 2012 | Canon EOS Rebel XSi Digital Camera

1 Answer

Lens error.....restart camera. Tried over and over again. Nothing works. HELP!


Went to the beach yesterday, by the end of the night my camera gave me this error: "lens error, restart camera". The lens would no longer come out.

I figured sand got stuck within the lens, so I did the following:

1. Turn camera up-side-down (with lens facing down)
2. Gently tap the sides of the camera (to loosen particles in lens)
3. Turn camera on
4. The lens will eventually come out
5. Gently tap the sides of the lens
6. Turn camera off (continue tapping side of lens as it retracts)

I turned the camera on and off a couple of times to ensure I removed all sand particles from the camera.

Now the camera works...thank god....


thanks.

Apr 11, 2011 | Canon PowerShot SX10 IS Digital Camera

1 Answer

My Kodak Easyshare M1033 camera fell while the lens was extended and now the lens won't go back in plus the camera won't come on. Is it possible the lens is already bad?


Hi there please follow the steps and let me know the result.
1. Ensure batteries are fully charged & clean the battery connector point in side the battery compartment.
2. Look carefully between the lens and the camera body for any sand, dirt or any damaged etc.
3. Try turning the camera with the lens facing down and shake to dislodge anything stuck
4. Try removing batteries and memory card, wait 5 minutes and refit the battery only.
5. Now turn on camera( with out card ) and see ,if working then fix the memory card & again turn on the camera. If working then fine . Otherwise format the memory card and fix back in camera again & try. Make sure before format the memory card take a back up all photos in your computer then format. If no luck then reset or restore the camera setting by pressing Menu key for 2 sec .. in not done the press both Menu & self time key for 2 - 4 sec.
i hope it will gives you success. Thanks & Before you leave, if you have found my information helpful and if you haven't already done so then please press the ACCEPT button, this is how I am paid for helping you today. POSITIVE feedback & bonus is appreciated

Feb 03, 2011 | Kodak EasyShare M1033 Digital Camera

1 Answer

I own a Casio Exilim and every time I turn it on it says lens error and the lens constantly get stuck. Please help with this problem.


Hi there please follow the steps and let me know the result.
1. Ensure batteries are fully charged & clean the battery connector point in side the battery compartment.
2. Look carefully between the lens and the camera body for any sand, dirt or any damaged etc.
3. Try turning the camera with the lens facing down and shake to dislodge anything stuck
4. Try removing batteries and memory card, wait 5 minutes and refit the battery only.
5. Now turn on camera( with out card ) and see ,if working then fix the memory card & again turn on the camera. If working then fine . Otherwise format the memory card and fix back in camera again & try. Make sure before format the memory card take a back up all photos in your computer then format. If no luck then reset or restore the camera setting by pressing Menu key for 2 sec .. in not done the press both Menu & self time key for 2 - 4 sec.
i hope it will gives you success. Thanks

Jan 17, 2011 | Casio EXILIM Card EX-S770 Digital Camera

1 Answer

Camera fell lens faced-down Olympus X-775


I don't think so, the motor is a sensitive part and probably is too damaged.

Jul 08, 2009 | Olympus X-775 Digital Camera

1 Answer

My digital Sony camera fell down Lens got stuck


Hi,
    As in short answer you have to replace the optical lens assymbly.Because due to heavy jurk its motor called sledge motor stsrt malfunctioning and it can not be changed component level. For this please contact any SONY SERVICE CENTRE nearby to you.
Hope you will understand.
Thanks for using FIXYA!

Apr 28, 2009 | Sony Cyber-shot DSC-H7 Digital Camera

1 Answer

Lens problem


The lens mechanism would seem to be damaged in some way.
There is normally no repair solution with this sort of thing because of the fine mechanism involved.

If you have someone you know who can work with fine instruments to take it to pieces.let them try.
I guess as no repair option is available you cant make it worse by trying to find out
Otherwise - new camera

Jan 16, 2009 | Sony Cyber-shot DSC-W110 Digital Camera

2 Answers

Goes off after lens come out.


Get it repaired under warranty. Sounds like a logic circuit problem.

Dec 10, 2008 | Pentax Optio S50 Digital Camera

1 Answer

Sony dsc-w55 fell and the lens is stuck


Use bit more force to push or pull the lens as lens has been damaged. If applying bit more force lens goes to working, u saved $$$ otherwise, new lens option is always available at Sony repair shops.

May 30, 2008 | Sony Cyber-shot DSC-W55 Digital Camera

Not finding what you are looking for?
Sony Cybershot DSC-S950 Digital Camera Logo

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Cameras Experts

kakima

Level 3 Expert

102366 Answers

james laughton
james laughton

Level 3 Expert

2166 Answers

JonSnell Electronic
JonSnell Electronic

Level 3 Expert

22068 Answers

Are you a Sony Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...