When i try to print its saying out of register colour so how do i solve this problem? and what is calibration?

yes, it is something of line. Color text is printed by three cartridges overlapping on the page. Most printer have a setting called Calibrate. You can sometimes do it in Windows, too.
Start button--> Control panel-->devices and printers--> (right click the name of the printer--> properties--> the last tab often is calibrate.

Difficult to say without seeing the quality of the prints but sounds like a calibration issue. By shaken to you mean that colours have fallen out of line and are leaving outlines on your prints? Possibly giving it a 3D-like effect?
If so I would recommend running a few calibration/alignment cycles from the printer or printer software to bring all the colours back into line.

You can usually calibrate your printer. When you first get your printer you may have to run through tests. One of them is where you print out a sheet with multiple colours on it and you then scan it to calibrate the scanner.Scanning will rarely give a perfect representation of the actual photo or image but if you do calibrate it may solve your problems.

try cleaning the printhead your printer seem to have an image quality issue

Simple oly when you know how ;-)

I think you have a slight blockage, to solve:- (dont know which printer or PCyou have so ill do my best)

Click on Start
All programms
Pick your printer from the list
Open the software
You will have 2,3 or 4 options depending on your printer spec.

You need to 1st remove the cartridge
Print 1 page with no INK a message will pop up saying con not print need ink for example.
You then NEED to calibrate your cartridge, you need to find:-
1 Align Cartridge/Nozzle - Unblocks, and Sets up. (Syncronize)
2 Calibrate Black - unblock black
2 Calibrate Colour - unblock colours
3 Print test Page - See how it looks
5 Align again - Unblocks everything giving good ink flow and gets the print right close to 100%
6 print test page!

It shoud now work ;-)

Good Luck xxx

Hi,


Try all of the steps on the link below but I would say steps 4 & 7 will help solve the problem, its just colour calibration but best to eliminate all the other steps just in case. Good luck


http://office.support.xerox.com/SRVS/CGI-BIN/WEBCGI.cgi/,/?St=266,E=0000000000024639231,K=7910,Sxi=17,Case=obj(79194)

Niallbt

What printer is it ? Some older ones need manual calibration, where patterns are printed, then you tell the system which is the best one. Newer ones can self calibrate, but still need it done. Go into your printers menu and see if you can find something on calibration or allignment.

I had similar problems when I first installed the printer and after different tests we found out that the Magenta ink print head was faulty. Changed head to a new one and problem solved. You will need to recalibrate and do paper set up's again.

When you changed the cartridges, the printer automatically prits a test / calibration page. This page must be placed in the scanner, then you have to press the "scan" key (the green one). It will calibrate an align the system. Then you'll be able to print.

my Cannon lpb 5100 colours are out of allignment (black OK) - error is "out of Register colours correction"
NOt sure how to solve this problem - calibration does not work?