Question about Denon AVR-1706 Receiver

1 Answer

Start up it gets to receiver on the displayit shuts off and Power indicator starts fashion red to green

It tunes on for 5 sec .
in that 5 sec . start up it gets to receiver on the display
it shuts off and Power indicator starts fashion red to green
iv disconcerted every thing and shut it down. it still dose it.
it was a result from haven it up to loud for to long . i think

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,071 Answers

Having too loud sound cannot damage the unit, the loud maximum sound is design for that unit, when its brand new one or 2 years old its okey.But when 2 to 3 or more years when voluming the maximum the it create a vibration that cause the "solder crack" and results intermittent sound goes on, goes off, that is your problem. You open the unit and got to supply section reheat or resolder the resistor, capacitor diode, transistor and most of all switching IC. when finish, go to audio section, do what u did in the supply section.Bear in mind not tosolder it causes trouble. When reheat all the solder, your unit is good as new.

Posted on Jun 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dennon gets hot shuts off


how are your four outside speakers hooked up? If you have four speakers hooked up to only two output channels on the receiver, the receiver is sensing a short and shutting down to avoid damage to the amp.

Jul 20, 2013 | Denon AVR-3806 Receiver

2 Answers

My yamaha htr-5640 receiver will turn on for a sec then a small click and then shuts down....no speakers hooked up....what is the deal?


Hi,

With the power off, try to disconnect every component and then power on the receiver. If it still shuts down, then it is an indication of an internal error and the unit needs to be serviced.

Regards,
Yamaha Support

Nov 28, 2011 | Yamaha HTR-5640 Receiver

1 Answer

My Panasonic SA-PT950 was working fine until one day I turned it on and it would not get past the "starting up" message. The 5 white dvd buttons flash white in sequence. There is a red...


This is why they print manuals.

Register and download the manual for free at retrevo.com

http://www.retrevo.com/search?q=panasonic+SA-PT950

"W1" page 5

Try powering the unit up with no speakers attached to see if it can get past the Starting message.

May 31, 2011 | Audio & Video Receivers

1 Answer

I have an Onkyo HT-R680. I have noticed after about an hour or more while playing Xbox or PS3 the sound will start to cut in and out. 5 secs of sound, 5 secs no sound. Continually like that untill I shut...


I've been having similar problems. I placed small fan to better circulate air in the closet I keep it in and that has fixed the problem so far. So some sort of thermal overload, I suppose?

Feb 23, 2011 | Onkyo Audio & Video Receivers

1 Answer

Shuts off then red light indicator flashes, disconnected all speakers but still wont work


Hi, this is a power board issue. remove the cover and make sure that this unit doesn't have blow fuse. if the fuse is fine, you will then need to replace the integrated power/ main board.

May 21, 2009 | Denon AVR-1803 Receiver

1 Answer

Denon avr 885 it automaticallyshuts off when i try to power it up


Its possible that the Receiver is going into protection mode and possible some speaker cable might have touched the body or with each other.
Remove all inputs and outputs and then restart the receiver. If it starts then you are lucky. Connect all cable and wiring properly and ensure that they do not touch each other. You might have to reset the microprocessor also.

If the problem persist then let me know to further the trobleshooting.

Please do rate this solution and thanks for using FixYa.

Mar 06, 2009 | Denon AVR-885 Receiver

1 Answer

Power Button Flashing Red


Try unplugging the entire unit and letting it sit for 5 minutes. See if this helps. If not, you need to do a complete reboot, which will cause you to lose your settings, but will probably solve your problem. To do a complete reboot, you will need to hold down two of the front bottons on the front panel. I'm not sure which, so either consult your manual or see other posts here which describe the reboot process for Denons. Hope this helps.

Dec 14, 2008 | Denon AVR-1908

1 Answer

Turns off after 4 secs or so....From Green to Red,


Receiver turns on Green but on pressing button again for red light standby, red light will not come on for this Denon receiver. Recently light came on saying Panel Lock is on. I was not able to get tuner to work.

Aug 25, 2008 | Denon AVR-1905 Receiver

2 Answers

Denon avr-2106 problem!!!


You're drawing too much power from it. Sounds like maybe your sub is hooked up wrong, double check that.

Mar 06, 2008 | Denon AVR-2106 Receiver

Not finding what you are looking for?
Denon AVR-1706 Receiver Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Denon Audio & Video Receivers Experts

 Elex
Elex

Level 2 Expert

49 Answers

jonpoint

Level 1 Expert

4 Answers

Tech Leprechaun
Tech Leprechaun

Level 2 Expert

61 Answers

Are you a Denon Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...