Washing machine programme error

>> check Motor carbon brushes.

I use to hhave to do that my was filter was blocked

An OE error presents if the washing machine has not successfully drained the water in ten minutes. Follow this link for step by step instructions for correcting the OE error code.

The FixYa Team

check the water level switching or door sensor

Hi,
The most common cause of an OE error code on a modern LG dishwasher is:
1. Blocked drain hose
2. Obstruction in the sump area (beneath the filter, which needs to be removed to check for onstruction)
3. Failing drain motor. 
else you need to REPLACE THE PCB POWER CONTROL BOARD
Good Luck!!!

Can you skip through the programme to drain? Press pause button. then press start to move the lights down to the empty cycle. leave to finish.

If you have already tried this, I can explain how to put machine into engineer test mode, which will then give out a fault code to identify problem.

If you found coins and such in the drain filter then there is a possiblility that the impeller in the drain pump motor was damaged and you are not getting good water flow thru it. The machine will error out and stop mid cycle if it detects it has not drained in a set amount of time. OE indicated a drain error. I suspect you need to have the drain pump motor assembly replaced.

The motor sensor has failed and needs to be replaced.  You will need to call a qualified LG technician to repair this problem.

take off the front kick plate on the bottom and there is a pea trap thats conected to the pump twist it off and see if it is cloged thats what usaully makes it not spin

sounds like your machine needs rebalancing..check the feet and floor to ensure it's level and balanced