My video cam shows warning on the monitor, Warning PSD NG

warning psd ng solution

2 CAPACITORS 22M/6V ON GYRO BOARD MUST BE REPLACED

PLease reset your camera then restart and try.
If not success then please visit service center.

Thanks, i am waiting for your feed back & if you satisfied then thumps me please.

I'll ask again... What brand/model of monitor?

Does it seem like a receiver-to-monitor On Screen Display message or is it something the monitor is warning about?

How are the the receiver and monitor connected?

No more sound from where? The TV. The speakers running off the receiver?

What source(s)?

Give us some clues, please.

hello there!
you must disassemble the camera and blow air aiming the ccd block area in the backside of the the lens with a duster spray by means :REMOVE THE LENS AND BLOW AIR FROM 20 cm distance,then reassemble the camera thoroughly and please do not use excessive force while doing it,mini DV camcorders are sensitive in handling ATTENTION qualified personnel only

I can help you with this.Disassemble the right side which includes the lcd display,so you can see the lens unit.Use a blower to blow air inside and point it to the lens.Better if you can remove the lens unit and blow air on it with caution and then assemble it back the problem disappears.
PS
If problem insists remove ccd block and apply inside a small amount of grease on the metal axis inside ois coil which is used for moving coil mechanism for optical stabiliser purposes.CAUTION THIS ONLY IF NO RESALTS WITH THE ABOVE METHOD.GOOD LUCK!

Hello! You need to disassmble the side which includes the lcd monitor, so you can see the lens and ccd block area. Blow air inside to clean the parts,and reassemble it .If the problem continues please let me know.There's another way then.

PSD NG means that there is a problem with your electronic image stabilization system.I think Panasonic got stuck with a bad batch of gyros. Take it back if you can, otherwise use lower resolution or hold very still when filming.

PSD NG is an error dealing with the OIS [optical image stabilization]. It can be fixed, it is not as terminal an error as many have rumored it to be. The caps could be a cause, but very remotely THE cause. You can have the camera sent in to Pani, and they will fix it, and you will get a bill for $300 - $600.

However the main cause for so many of the dvx100 series to have the psd ng error is loose cables. If you feel sure of your self with a screwdriver, tweezers, & forceps, you can make the repair yourself. In simple terms, all you need to do is reseat the ribbon cables. Follow the steps & photos here:

http://www.dvxuser.com/V6/showthread.php?t=172290

I did this repair with great success. It was a nerve wracking two hours, but I have not had the error reappear since. I got the camera from someone dirt cheap, [read 1/4 value], because of the psd ng error. I made the repair & not only have a fully operational unit with beautiful pictures, but I also quadrupled the value of it.

I think there is something worn in the lens.
I just give the the camera one or two sharp smacks with the heel of my hand
beneath the front body of the camera (not the lens),
That clears it up.

You can probably turn the stablization off too, but I think you also lose some display info.