Question about Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag neptune My washer mashine gets full of mold I cant get rid of it. The front door wont lock and so it wont do a spin cycle to ring out the clothes.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 413 Answers

When the door lock fails, there is a part on the electronic control board that fails (resistor burns up). Both will have to be replaced.

Posted on Jun 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Eratic, sometimes door lock doesnt activate, when it does wahser starts but stop mid cycle and wont continue. Replaced door switch and pump


Repair needed on Maytag Neptune washer - Home Improvement ...

www.dslreports.com > ... > Home Improvement

DSLReports
Aug 5, 2007 - 19 posts - ‎8 authors
Forum discussion: We have a Maytag Neptune front-loader washing machine that ...the drain/spin cycle after a wash even though the timer continues to ... related circuit board failure" their Neptune washer will lock the door, turn on the ... then will either not start tumbling or will stop operation mid-spin cycle.

How To Fix A Washing Machine That Is Not Spinning or ...

removeandreplace.com/.../washing-machine-or-washer-dryer-is-not-spin...
May 13, 2013 - The absolute first thing to do to your washing machine that will notspin or drain (whether it. ... I was so fed up with the machine sometimes refusing to spin or drain the .... I just did a load and it stopped midcycle with e and f error codes.... I tried different cycles but all that happens is the door lock engages ...

Maytag Washer Troubleshooting - YouTube



Dec 02, 2015 | Maytag Washing Machines

1 Answer

Neptune washer front door seal has black build up


Try pouring a cup full of distilled white vinegar into the soap dispenser drawer while it is filling up on a hot wash. Don't put any washing in, just let the machine go through the full cycle. Repeat if necessary.

You may be able to scrub lightly affected areas of the door seal with a scourer or old toothbrush etc. and something like Jiff. To be on the safe side you should wear goggles and a mask when dealing with black mold.

It may be worth trying a black mold remover available from supermarkets but read the instructions to make sure it is safe to use on rubber if intending to use it on the door seal. If badly affected - the only way to get rid of it - is to replace the door seal.

Nov 24, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag Neptune Washer, Model: MAH5500


The problem is with your door lock set.You may need to
replace it.If your lock is faulty the washer wont begin its
cycle.

Apr 08, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

I can't see it but my maytag neptune has moldly smell. How do I get rid of it?


Maytag's solution was to run an empty load using hot water and a cup of bleach instead of soap. According to them you are supposed to do this quite often. If the rubber ring that seals the door gets mold on it you are supposed to use a water/bleach solution and wipe it down with a rag.

Feb 16, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag washer


check to make sure the door is locking when it should. If the door isn't locking or sensing that its locked the washer will not go into high speed spin.

Mar 31, 2009 | Maytag Neptune MLG2000A Front Load Stacked...

2 Answers

Maytag front loader washing machine. Mould


How old is the washer? Did you try straight bleach on a towel and placed over the "mold" spot for about 5 minutes, be sure to wear gloves. Then scrub with a small brush being careful not to splatter bleach on yourself and rinse well. May need to replace the seal. I always leave the door cracked open after every use to "dry" out the inside and the boot. I also leave the drawer pulled out when not in use for that area to dry out as well. I have never had mold on the door seal of my Neptune washers, only the water holes above the dispenser drawer.

Sep 08, 2008 | Maytag MAH6700AWW Neptune Front-Load...

3 Answers

Door wont lock so it's not spinning


replace the doorlock instructions come in kit

Dec 13, 2007 | Maytag Neptune MAH5500B Front Load Washer

2 Answers

Maytag door wont lock and go into spin cycle


You will need to replace the door interlocking device.

Oct 26, 2007 | Maytag MAH6500 Neptune Front Loading...

Not finding what you are looking for?
Maytag Neptune MAH5500B Front Load Washer Logo

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Al Clark

Level 2 Expert

290 Answers

Todd Marr
Todd Marr

Level 2 Expert

77 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...