Question about Bosch Axxis+ WFR 2460 Front Load Washer

Open Question

Auto load adjustment problem

Our wfr 2460 front load washer reads 'auto load adjustment' at the beginning of the cycle. You than hear a 'click', the water fills, and than it doesn't start it's wash cycle or spin or anything else. What's the issue? Quick fix or not?

Posted by on

5 Suggested Answers

  • 1294 Answers

SOURCE: My Axxis wfr 2460 is not releasing the fabric softner from the drawer

You could try a tooth-brush. And after you fill your quantity of softener, top it with water till the exit level of the compartment. You could also check whether water actually pours into the compartment during the final rinsing of the clothes; in this case you should check the inlet pipe screens of your inlet pipe into the machine; which can be done without opening up the machine.

Posted on Dec 01, 2007

  • 1294 Answers

SOURCE: bosch wfr 2460 gb

Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too.

Rate me pl.....if helped.

Posted on Dec 29, 2007

  • 1462 Answers

SOURCE: Bosch WFR 2460 washer - Drum does not move during wash/spin cycles

possibly the motor brushes.
take back panel off and motor is held in by bolts which undo - also disconnect electrical plug and socket.
check condition of brushes

Posted on Oct 16, 2008

mumma_1
  • 903 Answers

SOURCE: WFR 2460 Front loader

take the soap dispenser drawer out and clean the inside where the drawer fits into. Then give the drawer a good clean including underneath it, it could be caused by soap build up.

Posted on Oct 27, 2008

barkencoa
  • 3463 Answers

SOURCE: door handle is loose and door can't be open

Remove the top cover, and release the door catch from inside the front of washer.
Please rate my solution.
Thanks.

Posted on Oct 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bosch washer goes through cycle but tub does not rotate


this sound like the brushes in the motor
or it might be a fault on the pump

Dec 30, 2012 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Hello, I just placed a load of laundry in my Bosch Axxis washer and set the dial to the cycle I always use. However, the water will not come into the washer, and now all of my clothes are stuck inside from...


Try selecting the spin prog, if there is any water in the washer, this will drain it, and you should be able to open the door.
Please leave comment as to whether this solved your prob or not.
Thankyou.

Nov 25, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

I have a bosch WFR 2460 washer. Er:15 error code.


You need to check and clean pump filter, normally located behind a removeable plastic cover at bottom front of washer right hand side.
If no filter found there remove rear panel of washer, and clean pump from rear of washer.
Please rate my solution.
Thanks.

Nov 11, 2009 | Bosch Logixx WFT 2806 Front Load...

1 Answer

Door handle is loose and door can't be openBosh washer WFR 2460


Remove the top cover, and release the door catch from inside the front of washer.
Please rate my solution.
Thanks.

Oct 30, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Bosch 2460 won't spin


only brushes in motor ,he taking the mikey motor only 236.00 from bosch

Jun 30, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer

2 Answers

Not spinning


Axxis+ WFR 2460 Front Load Washer This washing machine tutorial will show you what to do if the washing machine does not drain or empty the water out this repair was done on a Bosch, Neff and Siemens type appliance.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Dec 28, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Bosch WFR 2460 washer - Drum does not move during wash/spin cycles


possibly the motor brushes.
take back panel off and motor is held in by bolts which undo - also disconnect electrical plug and socket.
check condition of brushes

Oct 16, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

My Axxis wfr 2460 is not releasing the fabric softner from the drawer


You could try a tooth-brush. And after you fill your quantity of softener, top it with water till the exit level of the compartment. You could also check whether water actually pours into the compartment during the final rinsing of the clothes; in this case you should check the inlet pipe screens of your inlet pipe into the machine; which can be done without opening up the machine.

Nov 30, 2007 | Bosch Axxis+ WFR 2460 Front Load Washer

Not finding what you are looking for?
Bosch Axxis+ WFR 2460 Front Load Washer Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Tim Whalen

Level 3 Expert

3072 Answers

yadayada
yadayada

Level 3 Expert

70347 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...