Question about Sony FD Trinitron WEGA KV-32XBR400 32" TV

4 Answers

Default to channel 3

I have a Sony Wega TV hooked up to a Direct TV DVR. I was able to watch on channel 3, that was the default, or watch on video1. I played Nintendo Wii on the video1 setup. Yesterday, I left the Wii on the Wii menu, for an extended time and when I went back to it, the picture was all distorted and black and white. Now, I can only watch TV on video1. Can't watch on channel 3, which is the distorted channel, and also can't play Wii which is distorted when it shows on Video2 now. I've gone to the Sony menu and channel setup and can't seem to find the solution. Right now I can watch TV but can't play Wii with the way it is setup. What happened and how can I get it back to the way it was?

Posted by on

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,594 Answers

Hello,
I would strongly recomend to contact nearest Sony repair shop because your TV has hardware problem and it needs qualified service technician.

Posted on Jun 12, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 790 Answers

Hello sir ,

Try hard reset. unplug the power cord for 4 hours. Then, power it up again. You may have to do it twice to get a full reset.

Posted on Jun 12, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 230 Answers

Try give hard reset by unpluging all the cables and then plug all and check hope this will help you

Posted on Jun 12, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 1,894 Answers

Did u try as per manual?

Posted on Jun 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wii input channel on DirecTV


Fiend your solution direct from nintendo. Here is your solution....
http://www.nintendo.com/wiiconsole/prob676ijt65/solution


nilkhet19

Dec 29, 2009 | Nintendo Wii Console

1 Answer

Involentary channel switching


This is not an HD tv.Use the remote,came with the free rceiver converter box or pay tv tv box.

Nov 18, 2009 | Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

I can't play new wii via Sony Bravia TV and U-Verse DVR. Have power, synced controller - can't find correct channel


First make sure you scored in the correct cable entrances to ТV. Make sure you are on the right channel/AV/HDMI setting, if you have a multiple HDMI ports make sure you are on the right HDMI selection.

Nov 04, 2009 | Nintendo Wii Console

1 Answer

Tv keeps switching to Video1


this tv is defective the video circuit has a short in it I would if possible return for an exchange if it is out of warranty then a new vga board will be needed.

Apr 07, 2009 | Insignia LCDTV26 26 in. Television

1 Answer

Connecting to tv without s video


If your TV doesn't have direct audio/video input jacks, you can hook up your DVD/DVR/whatever using an RF converter. They are available in most retail stores and are inexpensive. You plug in the video and audio cables from the video device, and the output from the converter goes to the TV antenna input. Then you watch on channel 3 or 4, depending on how you set the converter.

Feb 15, 2009 | Sony Televison & Video

1 Answer

Hooking WII to TV


check your using the correct AV channel for the connection. Try another input connector eg Scart

Jan 20, 2009 | Nintendo Wii Console

2 Answers

How do you hook up a wii to this thing?


ok u can hook it up though a dvd player if ur tv wont support it make sure ur on the right channel though

Dec 25, 2008 | EA Sports Tiger Woods PGA Tour 08 for...

2 Answers

Sony FD Trinitron WEGA TV Model Number KD27FS170 volume problem


I had the same problem with the volume in digital mode and found the answer here: http://www.justanswer.com/questions/1m0ln-sony-fd-trinitron-wega-tv

The actual solution is towards the bottom of the post and hard to read through, so I simplified the instructions below:

On your remote control (with tv off)
1. press Display, channel 5, Volume Up and then Power
this brings up the service mode (you will see some green text on your screen)
2. Press channel 2 to scroll through options until you see "Micro" in the upper left of your screen
(channel 2 cycles up through the options, channel 5 cycles down)
3. Press channel 1 to scroll through suboptions until you see "DIOF" appear under "Micro"
(channel 1 cycles up through the suboptions, channel 4 cycles down)
4. Press channel six until the default value (12:60) changes to 12:40
(channel 3 increases the value, channel 6 decreases the value)
5. Once the value has been changed to 12:40, press Muting and you should see red text in the upper right hand corner that says "Write"
6. Simply turn the power off and back on for the change to take effect. Your volume problems should now be fixed.

Nov 22, 2008 | Sony FD Trinitron WEGA KV-36XBR800 36" TV

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-32XBR400 32" TV Logo

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

kakima

Level 3 Expert

101642 Answers

The Knight
The Knight

Level 3 Expert

71736 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1646 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...