Question about Hitachi 65F59A Television

1 Answer

Screen replacement i have single handedly manage to smash both screens on the very front and need to know how to proceed to fix it. i have located the parts and am having them shipped. i am however fairly handy is this something a novice should attempt?(hitachi 65f59a)

Posted by on

  • GRONZKY1 Jun 26, 2008

    thank you so much for your fukkin help this is a site of douche bags stay away..............................................

  • b mummel Sep 21, 2008

    both screens are busted and need to know where to find the part

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

I too am trying to fix this. I got the replacement part and I can't figure out how to repair the screen

Posted on Aug 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Broke mpthe mirror in my WS-55313 Mitsubishi projection tv while moving it. Just wondering how much it will cost to get a new one. Is less than 100 dollars reasonable? We dropped it while moving it and the...


A few notes:

First if the mirror which hangs at a angle facing the screens comes apart it can come forward and smash the inner screen.

The best way to proceed is remove the entire front screen frame:

remove speaker grill on front under the screen (if cloth it should pull out in one piece (a few are two piece).

With it removed look under the bottom front edge of the screen unit--left to right there are several identical screws and you have to remove those.

If the front controls (vary by cabinet style) are in the bottom front of the screen unit there will be wires from them hanging down--should be an inspection plate dead center behind where the grill was.

follow the wires from the front control board down with the inspection plate removed and locate the one or two inline plugs and disconnect them (they pull apart and are marked)

With the screws at bottom of screen frame removed and the keyboard free pull out the frame from bottom and slid up about 4-6 inches the entire frame with the screens still in it.

Do not when you do this twist the frame as you can pop the screens right out.

Set the frame and screens to one side making sure not against the screens and avoid touching the inside screen inside the frame.

You should now be able to see the mirror clearly, be careful if cracked as when you release the screws that hold it in it may come apart and use gloves---broken mirrors are very sharp.

Mirror should if you see the plastic and wood slots for it not be too hard to remove and replace. Vac out any small glass as light from the set inside can reflect onto the new mirror or even the inside of the inner screen and be seen in the picture.

You almost certainly are going to have to get the mirror from Mitsubishi---price it with shipping but since its a 55 inch mirror almost any mitsubishi mirror that size will work perfectly--some shops save them....hint.


Most of those mirrors were at or over 100 dollars and a few sites on the net sell replacements in case Mitsubishi is too high.

Hope this helps and let me know if need advice.

Dec 06, 2012 | Mitsubishi WS-55313 55" Rear Projection...

2 Answers

My screen has blue and red lines across it. Now the red lines are becoming stronger and the screen flashes red until it turns off. how do i fix this?


This is for if the lines are thin and in the form of an arc across the screen.

You need to turn down the screen voltage for the blue and red CRT. I believe the access is through the front on that model.

1) Remove the front grill
2) There should be access panel you need to remove once you remove the front grill. This is where the screen voltage adjustment is located
3) Look for a small black box with six knobs on it. One row is for "Focus" and one row is for "screen". It will be marked, but probably need a flashlight to see which row it is. There will be a "R", "G" and "B" next to each knob to represent Red, Green Blue respectively.

4) Careful with the access panel removed, you are only inches away from very dangerous voltages.
5) slowly turn the R or B knob counterclockwise until the lines on the screen disappear.
Keep your hands away from everything else and only use one hand near the tv. put the other hand behind your back.

6) Once corrected, replace the panel and put the grill cover back on.

Feb 19, 2011 | Sony KP-57WS500 57" Rear Projection...

1 Answer

You see red and blue lines curved across the screen when there is a blank screen


You need to turn down the screen voltage for the blue and red CRT. I believe the access is through the front on that model.

1) Remove the front grill
2) There should be access panel you need to remove once you remove the front grill. This is where the screen voltage adjustment is located
3) Look for a small black box with six knobs on it. One row is for "Focus" and one row is for "screen". It will be marked, but probably need a flashlight to see which row it is. There will be a "R", "G" and "B" next to each knob to represent Red, Green Blue respectively.

4) Careful with the access panel removed, you are only inches away from very dangerous voltages.
5) slowly turn the R or B knob counterclockwise until the lines on the screen disappear.
Keep your hands away from everything else and only use one hand near the tv. put the other hand behind your back.

6) Once corrected, replace the panel and put the grill cover back on.

Feb 17, 2011 | Sony KP-57WV600 57" Rear Projection...

1 Answer

How did I correct blue and red lines curved across a blank screen of my KP-57WV600 SONY Projection TV?


This is for if the lines are thin and arc.

You need to turn down the screen voltage for the blue and red CRT. I don't remember if the focus block is in the front or in the back of the tv on this model. Most projections have them in the front.

You could check the back access panel and look for a black box with six knobs as descibed in step 3 below. This is what you are looking for.

follow the steps below if it is located in the front:

1) Remove the front grill
2) There should be access panel you need to remove once you remove the front grill. This is where the screen voltage adjustment is located
3) Look for a small black box with six knobs on it. One row is for "Focus" and one row is for "screen". It will be marked, but probably need a flashlight to see which row it is. There will be a "R", "G" and "B" next to each knob to represent Red, Green Blue respectively.

4) Careful with the access panel removed, you are only inches away from very dangerous voltages.
5) slowly turn the R or B knob counterclockwise until the lines on the screen disappear.
Keep your hands away from everything else and only use one hand near the tv. put the other hand behind your back.

6) Once corrected, replace the panel and put the grill cover back on.

Feb 17, 2011 | Sony KP-57WV600 57" Rear Projection...

1 Answer

I get blue line ine the screen when it balck


This is for if the lines are thin and arc.

You need to turn down the screen voltage for the blue CRT.


follow the steps below:

1) Remove the front grill
2) There should be access panel you need to remove once you remove the front grill. This is where the screen voltage adjustment is located
3) Look for a small black box with six knobs on it. One row is for "Focus" and one row is for "screen". It will be marked, but probably need a flashlight to see which row it is. There will be a "R", "G" and "B" next to each knob to represent Red, Green Blue respectively.

4) Careful with the access panel removed, you are only inches away from very dangerous voltages.
5) slowly turn the R or B knob counterclockwise until the lines on the screen disappear.
Keep your hands away from everything else and only use one hand near the tv. put the other hand behind your back.

6) Once corrected, replace the panel and put the grill cover back on.

Feb 16, 2011 | Sony KP-57WS500 57" Rear Projection...

1 Answer

My hand went in and smashed the screen on my toshiba need new screen


pigdigger,

I have bad news for you, the total cost for the three screens you will need will be about $290.00. They can be obtained from http://www.encompass.com . Here are the part #s: Fresnel 23311898 $80.00, Lenticular 23311897 $120.00 and Protector 23311863 $90.00.

Installation is straight forward. Generally you have to remove the back top cover with the mirror attached. Then check under the bezel on the front, below the screen, for several screws. Remove the screen and lay it flat on the floor. Remove the screen hold in screws or clips. Remove the screen.

Assemble the new screens. Make sure they are in the correct order. Protector (on outside), Lenticular in the middle and the Fresnel on the inside. You will need to secure the screens together. Black cloth tape works well around the perimeter. Reinstall the screen into the frame and reassemble the unit. This should complete the job.

Thanks for using FixYa and for the great rating.

hardrocko

Sep 29, 2010 | Toshiba 42H81 42" Rear Projection...

1 Answer

Cracked front screen need replacement


Hi,I've been looking every where online to see who sells screens and haven't found a single website.I suggest to contact the manufacturer to see if the sell it.I know that the price its very costly and sometimes it's better to buy another tv.Have a blessed one!

Mar 26, 2010 | Projection Televisions

2 Answers

TP50H50 Screen Broken


The Toshiba part number is: 23837513

But it is listed as no longer available .. all you can do is call parts dealers to locate

Jan 05, 2009 | Toshiba TP50H50 50" Rear Projection...

1 Answer

New screen


Call Union Electronics at 800-648-6657 ext. 4911
They will need your make and model number of the tv.

May 28, 2008 | Hitachi 51F510 51" Rear Projection...

1 Answer

I HAVE SMASHED MY SCREEN ON MY SAGEM AXIUM D56B HD TELEVISION,WHERE WOULD I FIND THE PARTS.PLEASE HELP


You wont get a replacement screen on this model as its suppliers dont make a replacement screen. But I do know someone that has got one of these as parts for sale.
01280701160 is the number he is in the uk.

May 01, 2008 | Projection Televisions

Not finding what you are looking for?
Hitachi 65F59A Television Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...