Looking for owners manual for Landa PC4-2000 pressure washer

This appears to be a Pressure Washer, so moved it from Washing Machines.

If you have no spark, then the switch, the coil or the ignition system is faulty. If it is just the burner heater, then the spark lighter is faulty. This suggests that your battery needs charging with a battery charger to bring it up to full power.

The 12 VDC burner systems can draw as much as 18
amps! For such motors to run properly, the battery and
engine charging system must be kept in good condi-
tion, and the engine must run fast enough to adequately
charge the battery. Do not throttle down the engine for
any length of time.

https://www.manualslib.com/products/Landa-Mvc3-3000-8920570.html

..

Check out the trigger mechanism. Water should come out at any time, even when you do not have the unit started.

to get this answer it is simple , google landa pressure washers then look for your model number and that shall tell you the exact oil you need

The engine will use standard 30W motor oil. The pump will use 30W non-detergent oil.

Sincerely,
Aron Kerr
Landa Northwest
www.landanw.com

When using the chemical injector your machine is only having to operate under low pressure. This means that your pump only has to transfer water and does not have to compress it. When you insert a pressure nozzle you cause the pump to have resistance and therefore it has to compress the water to make pressure. If you pump seals or valves are worn the pump cannot build this pressure. You need to either rebuild your pump yourself or have it looked at by a service center. If you have any other questions or need parts or service please feel free to contact me using the information below.

Sincerely,
Aron Kerr
Landa Northwest
800.247.8103
503.255.6508
www.landanw.com

Landa does not have a model HMP so I am not sure which machine you have. If you can provide a full model and serial off of the model tag on the machine I can provide you with a digital copy of the manual you are looking for.

Sincerely,
Aron Kerr
Landa Northwest
www.landanw.com
800.247.8103
503.255.6508

Check for 12V at the igniter connector with the unit running. If you have 12V and no igniter it may be stuck or bad. Thrun the unit off and read continuity across the DISCONNECTED igniter plug / terminals to the igniter. No resistance = open igniter.

If all of the above checks out your going to have to look at the fuel pressure switch to see if it closes and passes 12V to the igniter.

Before you give up... Check the fuse.

Landa's website is www.landa.com
You will have to select a local dealer for parts.

Thanks for using FixYa!

Kelly

Were I to pick from one of those three, I would pick the Landa. The most reliable pumps are Hotsy and since Karcher bought Landa and Hotsy, those three brands now have Hotsy pumps, though it doesn't say it on the machines.

send them an email at [email protected] or contact them directly at 800-526-3248 for more info specific to your model which was not listed above. hope this helps you