Question about Recoton Advent Advent Q2035A 20" TV

1 Answer

Laptop gone dark

Starting my laptop, the screen is completely blank. The right start up lights are on, but nothing happens. Help!
John

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 25 Answers

This sounds like a burned out backlight lamp.  Had that happen to a Mac laptop used at work:  all the boot-up LEDs and sounds occurred, but a dark screen.  It was fixed promptly by our computer guy, who is pretty amazing at fixing computers.  So all I can tell you is that it shouldn't be a particularly expensive repair.

Posted on Jun 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Picture is very dark.


Sounds like the screen voltage has been gone very low than normal. This might happen, if the CRT base socket have any damage. If you wish to get more details, check the site linked here. Surf the site in "MOSAIC" view.
http://electronicshelponline.blogspot.com/

Jan 21, 2014 | Sony WEGA KD-34XBR970 34" TV

1 Answer

Panasonic TV TC-2175C, display turning dark


There are mainly two reasons for this fault. The first one is with its screen voltage settings. If the screen voltage settings have gone down [it can be happen automatically in rare cases], the screen will look dark. The second one is with its video output section itself. Anyway, you have to seek an experienced service technicians' help in this matter, if you are not handy in electronics.

Jul 02, 2012 | Panasonic CT-27G13 TV

1 Answer

Set will often have problems starting back up


you have a high voltage arching problem. the crt has about 33000. (thirty three thousand) volts on it. the anode lead is arching to the chassis(ground) around the crt(picture tube). the anode lead is the big red wire on the very top of back of crt. with the back off, you will see the big red wire and it will have a suction cup about 4 inches round connecting to picture tube. unplug. silicone around suction cup. let dry for 24 hours. enjoy. you might get a little shocked even when unplugged, but wont hurt you.

Nov 12, 2009 | RCA MM36100 36" TV

1 Answer

Red cirle in the center of my screen durning dark scenes


This sounds like the light engine has gone bad or has dust/dirt in the light tunnel or DMD assembly. The light engine would have to be removed to check for dirt. If the engine is bad it can cost over $800 just for the engine not including shop charge. Unit would need to be taken to a repair shop to find out what is actually causing the problem.

Sep 06, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

I have a sony bravia lcd but i am not getting any power the red light at the bottom is not on checked the cable changed the fuse but nothing help pleases regards john


the intergrated power supply or transformer gone faulty you shud inspect and replace that part
to locate the power supply fllow the power corde!

Jun 05, 2009 | Sony KV-36XBR450 36" TV

1 Answer

TV SREEN GOES BLANK, BUT AUDIO CONTINUES NORMAL,


Try unplugging for 36 hours. I had the same problem but with no sound and picture

Mar 03, 2009 | Sony KP-53HS10 TV

1 Answer

Hitachi screen went blank?


1) Consult service manual for details.........procedure issues?
Sounds like the digital convergence unit got confused....
You may have to start all over again at default....
2) When converging a PTV, less is better ( adjustments) unless
you are positive adjustments will yield some improvement..
3) Info source = www.HitachiServiceUSA.com

Please rate this solution.............................

Nov 03, 2007 | Hitachi 43FDX01B TV

1 Answer

Philips 29PT8419-79R


the problem in power supply. if its output is ok than you will have to check horizontal section.

Sep 15, 2007 | Philips 27PT8420 27" TV

1 Answer

Blank screen, no sound


If ti blinks three times, then it may be an issue with the flyback transformer. It's called "three strikes"...it tries three times to come on, and after that enters a safety shutdown mode to protect the TV. Might need to have a professional shop take a look at it.

May 02, 2007 | Durabrand DWT1905 TV

Not finding what you are looking for?
Recoton Advent Advent Q2035A 20" TV Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Recoton Advent Standard (CRT) Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68229 Answers

Are you a Recoton Advent Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...