Question about Sharp 20K-S100 20" TV

1 Answer

My tv is turn to red light when i hit the power button

My tv has power but it turn into red light when i hit the power button.. please help me about this! thank you..

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 54 Answers

Some circuit in secondary power has a leak or shorted parts need to replace it. thats why your tv comeback to red ligth signal. need a technician.

Posted on Jun 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I pressed the power button, but the tv wont turn on


Please check if the power cord is connected properly in the wall outlet and in the TV. Check the wall outlet. Has it got power? Check if there is red light when the power is switched on at the wall outlet. If there is red light then press the power button. Does the TV turn on? If not then your power button is defective and requires replacement as it is not making contact. Also please try to start your TV WITH THE REMOTE CONTROL. At times it helps.

Feb 12, 2011 | Sanyo Standard (CRT) Televisions

2 Answers

My Loewe Aconda TV will not turn on - buzzing noise.


My Loewe Aconda 81 HDR TV will not turn on. When I press the power button the green light comes on but the red light stays on with it and after a few seconds the green light goes out and the red light stays on. Any help please.

May 15, 2010 | Loewe Aconda ACO9383 38" TV

2 Answers

Sony WEGA Trinitron SRS BBE 32'


Hi,
Please reply couple of questions about TV to guess what could be wrong.

1- How many times standby light blinks, there would be interval of 3 seconds in blinks so count pause to pause.

2- Please intimate exact model of TV, written on sticker pasted at back of TV. That will help me to check its schematics.

Hit " add a comment" button to reply.
Thanks.

May 03, 2009 | Sony FD Trinitron WEGA KV-29LS35 29" TV

2 Answers

TV doesn't turn on, red light flashing


numder of flasing indicate error code . so i need how many flash you can see when power on the tv using front power butten then i will suggest the solution

Jan 15, 2009 | Sony KV-32S45 32" TV

2 Answers

Sony FD Trinitron WEGA KV-24FS100 24" TV On/Off problems


I have spent about 4 hours tonight researching several tech sites and the Sony service manual for the same problem with my Sony KV-32HS510 unit. I was able to download the manual from a website http://www.eserviceinfo.com/downloadsm/31649/Sony_KV-32HS510.html and a TV Repair training lecture paper at http://www.repairfaq.org/sam/tvfaq.htm#tvhvp .

These TV sets have a safety feature where it will shut back down if a high voltage is indicated. Unfortunately, the electronics for these safety features are not very reliable and give false indication. Letting the unit sit off lets the capacitors leak voltage as well as cool off. These two factor help with the unit not falsely indicating a high voltage condition.

The D Board seems to be the most common failure component, but a 6 times flash could be an overcurrent/voltage failure from the A, B, or M boards. A 7 times flash is a Horizontal Deflection Stopped error with no additional information given in the manual for a fix. Again, in most blogs, the D Board seemed to the source of the failures.

A refurbished D Board part no. A1300319A can be bought for around $200 with a new board at $550 per the www.partstore.com site. Then add $100-$200 for an actual TV service technician and you have a repair bill approaching the costs for a new flatscreen TV.

Some tech types posted that they have actually repaired their boards by replacing individual components for around $40. You may find a service shop that can do the same component level repair at the $100-$150 level cost. It turns out that the closest authorized Sony repair shop is 2-1/2 hours away from us. Good luck finding someone close by.

We were able to get our TV to come back on after dozens of attempts and plan to leave it on until it dies all together. I may attempt my own D Board replacement when the time comes.

Good luck!

Dec 14, 2008 | Sony FD Trinitron WEGA KV-36XBR800 36" TV

2 Answers

It takes 5 to 7 minutes to turn on my Magnavox HD TV


IFyou feel confident and can locate switch mode power supply with back removed.
Try warming switchmode power supply before turning TV on.
If TV turns on normaly then there are some small capcitors that are a common cause of this fault.
Otherwise look for DRY or CRACKED solder jointson PCB
BUT DON'T do any of the above if your are not confident send it to a TV repaiman.

Sep 11, 2008 | Philips Magnavox MS2530C 25" TV

1 Answer

Tv wont turn on only clicks and then flashes red timer light


tv wont turn on when i hit power it makes the clicking noise like it is going to turn on, but never does and the red timer light next to the power button just flashes.
help!
trinitron kv29f1u
only clicks and blinks

Jul 26, 2008 | Sony KV-35S42 35" TV

1 Answer

Tv wont turn on only clicks and then flashes red timer light


Well, I have found out that the number of red light blinks is a "blink code" that indicates the nature of the fault with the TV. Usually these are various failures of internal fuses or circuit boards. There's a fair amount of information on threads at techlore.com on this, so try searching there. Teh specific codes and manuals are usually it seems under license from Sony and not available for free to the public. Sorry!

Oct 17, 2007 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

TV wont turn on and blank screen & no sound


this unit is dead ,possoble power supply problem. you must have warranty on this unit if its only 8 months old,if not contact place of purchase and ask wath is the life expectancy of their products and your tv set it start them thinking about repairing or replacing.

Aug 22, 2007 | RCA F27650 27" TV

1 Answer

TV turns on......eventually


check for a bad cap ,relay sound ok or could be a bad solder connection in the power supply at the regulators

Dec 13, 2006 | Sony FD Trinitron WEGA KV-24FS120 24" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68301 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Cindy Wells

Level 3 Expert

4757 Answers

Are you a Sharp Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...