Question about Hotpoint Aquarius WD640 Front Load Washer/Dryer

1 Answer

Hotpoint erorr f01

My washing machine goes through all the wash cycle but then sticks on 1min left before rince and spin and sometimes comes up error f01

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 66 Answers

Sounds like a faulty water valve regards jason

Posted on Jun 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hotpoint aqualtis AQXXL 129PI


could be a bad timer? sticking at the wash cycle. it does agitate right? other wise bad water pressure switch

Aug 07, 2014 | Hotpoint Washing Machines

2 Answers

My machine is displaying code F01. It comes up at the end of the wash cycle. However, It doesn't seems to be actually washing the clothes anymore. The water runs in and out of it , but I don't...


I tired answering yuor post and there is a problem with the website. I have reported same to the website staff. You should see my post via email soon

Kelly

Sep 24, 2011 | Washing Machines

1 Answer

Hotpoint Ultima washing machine: F-01 What does this mean?


The Hotpoint manufacturer's site says this code means:
F01 - Short circuit motor triac - Book a washing machine repair.

However, what it means is that it could have a faulty motor or motor control board. The motor tachometer could also be faulty. Some machines have a little rotating magnet and sensor, and the magnet can become detached. If this code is not constant, and tending to come on during a spin cycle, check the drive belt for wear or slack, and check the motor brushes.

Aug 08, 2011 | Hotpoint Ultima WF860 Front Load Washer

1 Answer

Machine reads F-01 at end of cycle. Sometimes final spin cycle repeats itself several times during last minute of cycle.


F01: Aquarius and Ultima models may show this. It could be a faulty motor or motor control board. The motor tachometer could also be faulty. Some machines have a little rotating magnet and sensor, and the magnet can become detached (not sure about these though on this model). NOTE: if this code is not constant, and tending to come up during spin, check the drive belt for wear or slack, and check the motor brushes.

Jan 27, 2010 | Hotpoint Washing Machines

1 Answer

Hotpoint washing machine wf740


Error F01 is indicating that the motor triac has short circuited, this is part of the electronic speed control for the motor.
Hotpoint's advice is to call an engineer, and I would concur with this, it is not really a DIY repair, unless you have a good knowledge of electronics.
Plz rate my solution.
Thanks.

Jan 25, 2009 | Hotpoint Aquarius WD640 Front Load...

1 Answer

Error message f-01 on hotpoint ultima wt741 washing machine


F01 is a motor faulty normally caused by the module,but sometimes thewiring to the motor plug that works loose as its to tight,give them alla good wiggle make sure there all in!
check this link for other error codes of hotpoint machines
http://www.hotpointservice.co.uk/hs/pages/content.do?keys=FAQ:ERROR_CODES

Dec 15, 2008 | Hotpoint Ultima WD72 Front Load...

2 Answers

Bosch classixx 1000 washing machine - stops on spin


Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Apr 29, 2008 | Bosch Classixx WVF 240S Front Load Washer...

1 Answer

Hotpoint WD440


Bad door latch or Control board is bad

Apr 28, 2008 | Hotpoint Aquarius WF000 Front Load Washer

Not finding what you are looking for?
Hotpoint Aquarius WD640 Front Load Washer/Dryer Logo

Related Topics:

649 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

hungoverrr

Level 1 Expert

5 Answers

puggy666

Level 1 Expert

47 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...