I have an electric mobility scooter 302Le that is fully charged but will not run. The lights and horn all work but the scooter will not move. The led light in the control box flashes five times. Can you tell me what's wrong?

I think the the fuse is under the head light cowling glass type 25 amp fuse. Your throttle, motor wiring, or controller maybe causing this problem.

I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

Not familiar with your particular scooter - but I am well versed with electricity. The issue you're seeing is likely a result of a poor connection somewhere. The amount of power (current in amps) required to operate the horn or lights is a small fraction of that needed to run the motor.

You should trace larger sized wires/cables from the motor back as far as you can - ideally to the battery if possible. Remove, thoroughly clean and reconnect each of these cables under each terminal screw - one at a time. This way you'll know any unconnected cable goes on the only terminal that is removed.

At this point, you should have 100% good connections for all high current loads - including the motor and will probably be able to use the scooter. Placing the battery on a slow trickle charger overnight will help ensure that the battery is fully charged - not just enough to operate the horn or lights.

Good luck!

Make sure it isn't in freewheeling mode,
Also check brake and motor connections.
Let us know what you find.
thanks

I would get the batteries checked for power. Just because your charger shows fully charged quite often the batteries are low but enough power for lights or horn which does not take much power. i suspect bad batteries.

There is no tilt switch. It can time out though, but just turn it off and on again.

I have the same problem in mine.. But the beep is continous. Mine is a fortress 2000 AT. anybody knows what's the trouble on this one?

Your break release shifter is in the push the scooter mode. Put it back in gear and the horn doesn' beep and it should run..
The horn beeping is the alarm to tell you the break release is on.

It is usually located under the seat on the body of the top of the battery housing. Looks like a stick with a ball on it.

mcdevito75 here, Is the battery fully charged, if not, Charge battery, if Charged double check connection at battery and motor.

ok, that can be a number of things, first of all trying moving the throtle to the left slight then turning on, thry the right side as well, now the idea is if the pot (wig wam etc) has moved it means the throtle is in hte wrong location otherwords a error ,

Regards
GeWiz.

the motor is not working perfectly and chnge motor or check the connection perfctly