Having a problem with one of our label printers, a Zebra S600.
When printing multiple labels, the position of the printing gradually steps closer to the lead edge until it is actually printing off of the label.
It seems like it is set up for the wrong size label, but I have checked this and the settings are correct.
388 views
Usually answered in minutes!
the zebra printer that I have prints out similarly....slowly the print goes out of position untile the label is being printed on two lables
That's the same problem we have now. It didn't occur during the first two or three years of use of our Zebra S600, but now it´s getting really annoying. I know there is this "print mode". In one print mode the printer calibrates itself, consuming a lot of labels in doing so, and printing flawless, says our local Zebra support. In the other print mode, that is "continuous", the label ribbon is positioned manually, and printing is controlled exclusively by the software used for formatting label's content (this mode doesn't work well, says our local support). Problem is: why did it work before, and now it will not?
×