- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
above is a generic training manual, this will give you an idea of whats required to service and repair a unit such as this. usually when this happens, it is a Power Supply that has taken, a power spike, surge etc. usually they are cheaply repairable, from you authorised service center, Akai, in your case, ask for a "Quote" before proceeding with any work, that way at least you will get an idea as to weather repair or replace.
Hi hannah. The simplest way to remove stuck tapes is to remove the top cover. Usually just a couple of screws. Then remove the stuck tape and put the cover back into place. You can also look for emergency eject hole and insert a snall pin into the hole and attempt to eject the disc while repeatedly twisting the pin inside the hole.
You need the remote working to get at the on-screen setup menus.
make sure the remote is set for the VCR (VCR button) and try the menu
button. Are you sure this is the right remote for the VCR.
May have to get a new remote. Make sure it is a universal that
has a MENU button.
Please explain what you mean by "tuning in." Are you referring to hooking up to your Television, or to a cable/satellite box? Or can you not see video when you play a VCR.
Check your hookup cabling. With a cable or satellite system, the VCR normally is hooked between the cable/sat receiver box and the TV. Cable box RF output to VCR RF input, VCR RF output to TV RF input.
There are other possibilities when your TV has video or line inputs.
Well from memory... you have to Plug in the Antenna to the Video, then from Video to TV, then ya Tune in the "Tuner" section of the Unit.. that outputs on ya TV, then you can simply press the record button(s).. also there is the option of Timer Recording... There was also a TV/VCR switch that had to be toggled on some models...
But ya really need a manual I believe the manual is at the below link...
sorry but there is not a reset button and it looks to me as a damage chip is truth that tere is a mute option in your vcr but I have fix that problem before and was a bad chip look for a teh to help you but remember a new vcr cost is verry low so dont spend to much in that one..good luck