Re: The only window that is working is the drivers. Is...
Possible that you activated the "child safety" mechanism when cleaning the interior. To correct, use the botton above the driver's window button. Worth a try!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
On some cars when you disconnect the battery for whatever reason certain electrical areas will not be restored to operation after the battery is reconnected. You need what they refer to as a radio code to restore radio and other circuits to operation. The code should be in car manual. If not contact the dealer for the radio code for your car.
there is a possibility that the CPU program has been comprised by you mistake If you can get a scanner the reset the program by using it . IF not some times by removing the earth strap from the battery for say 15 seconds may reset the CPU.. What have you got to loose.
Drop it into neutral and try starting it there, if not check your fuses, could be a fuel pump or engine fuse that has blown. Also try a different key, the transponder may have failed in that one. good luck.
I think you're in luck. There is a recall for the master switch due to this very issue. Act like you don't know what's wrong, they'll need to replace it to an updated one that won't be so prone to water infiltration.
Sounds like a fuse problem. Check your fuses. If you need help find the exact fuses for power windows, look in your owners manual. In many cases, they can be in the engine compartment or the drivers kick panel. If you cannot tell if a fuse is blown, use a volt meter set to check continuity. If the voltmeter reads 0 or .1, the fuse is fine, if it reads 1, the fuse is blown. Hope this helps
If the power window itself still work fine, and the illumination on the driver's side door lock still work, then the LEDs behind the switch are the issue ( usually bad solder joints ). If you are talking about all doors other than the driver's side, do you have the window lock on ? The lights on the switch turn off when the driver's side window lock is enabled.
It's either a master fuse for the whole window system (if your car has that) or it's the switch module on the driver's door. All the window power is routed first to the driver's door, then out to the others. If your master switch on the driver's door dies, you'll lose all the window controls. Check fuses, and if they're OK, replace the driver's door switch panel. Once you do that, you should be fine.
It would be a switch. Try pushing the switch down hard and wiggling it. It may work which would indicat a switch. Since one direction works It has to be the switch ,
×