Question about Washing Machines

1 Answer

I got a Frigidaire Eurodesign washing machin three years ago. It worked perfectly. but since one week, at the end of each cycle, the final spin doesn't work. Exemple, if I choose only the Drain/spin cycle, the once draining time completed, at 7 minutes of the end, the machin shut off. Any can help me please?

Posted by on

  • 1 more comment 
  • daphka Jun 16, 2008

    I bought my washer and dryer three years ago too at Brault and Martineau and I have a problem since day 1 with the washer...the door has a gap but no one is doing anything about it and it shakes so much you feel it even in the kitchen. But when the guy came he told me it was normal. Everyone I know has one and it doesn't shake the whole house! And it's on a ceremic floor. As for my dryer, in the first year the electronic panel blew up twice and recently i have a problem with the part that accumulates the lint. Our clothes get's stuck on it and it tears the clothes. But again no one is doing anything about it even though i have a 5 year waranty. I have no solution either because once you bought it they don't care.

  • trado1999 Oct 28, 2008

    I think we were had with this brand. My spin cycle stopped working three weeks ago, it's a one year unit, purchased October 12, 2007. It should be lasting at least for the duration of the warranty but no... I called a repair company, the one I'm supposed to call for warranty service. They forgot to come a first time, then came and told me they did not have the part. I've been waiting for 2 weeks now and still haven't had a repair. The electronic timer is the defective part. It is the part that regulates the cycles. Too bad for us... We've been cheaped out with poor quality.

  • colljon Dec 06, 2008

    I got a Frigidaire Eurodesign washing machin three years ago. It worked perfectly. but since one week, at the end of each cycle, the final spin doesn't work. Exemple, if I choose only the Drain/spin cycle, the once draining time completed, at 7 minutes of the end, the machin shut off. Any can help me please?



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I got exactly the same problem and I changed the lock door and everything worked.

Posted on Dec 06, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Had door replaced because of broken hinges door switch replaced, computer replaced and the machine is cracked and is to be fixed next week BUT my ? is why does the spin cycle take so long to kick in and...

Frigidaire is normally a good product Please dont be mad at them just seems to be a bad one it happens.
long spin and drain cycles are normally caused by restricted water flow. you will need to have the drain pump and coin trap checked for obstruction be sure to remove the drain boot from the bottom of the wash tub top check for foreign objects.
In rare occassions the speed sensor can be bad.

I hope this helps and your machine is finally fixed right.

Happy New Year.

Jan 01, 2011 | Frigidaire Washing Machines

1 Answer

Model #ftfb4000fs1 frigidaire front load washer will not go into final spin --- drains but will not spin dry

Just had this problem last week. The problem was the door switch, which made no sense to me since the drum still turned on the other cycles. But the repair shop replaced the ($76!) switch and the machine now works fine.

Oct 21, 2010 | Frigidaire ATF6000ES Front Load Washer

1 Answer

25 years old,top load. put on new belts 3 weeks ag...

Timmer may be bad. Bad contacts on timmer for spin mode. Check to see if timmer goes though cycle to end. Also check lid switch.

May 17, 2010 | Washing Machines

1 Answer

I have a top loader and it will not spin.

Good day,
If it will fill normally, wash normally, and then just quit when trying to pump out and spin, then it would be a bad lid switch.
Be aware there are three locations for the screws holding the top console. Both bottom corners with the screws exposed. The same but the screws hidden by end caps that must be unclipped, and finally at the bottom rear of the console.
As well there are three different lid switch styles. Your parts house will sort that out for you if you have a complete model number.

P.S. If the hyperlink fails, just highlight and put in the address bar of your browser.

Jan 26, 2010 | Washing Machines

1 Answer

Frifidaire front load shuts off before spin

Dear Friend
ngfam1 here for you!
I am happy to be of assistance!

Since your machine does not work perfectly, My professional opinion is that only factory service will remedy this malfunction!

Here is a good service that I recommend to my customers,
in our 65 year old appliance business!

A&E Factory Service
1-800-905-9505 -(IN U.S.A.)
They are open to make appointments 7days/24hours
A&E is factory authorized service for most brands!
Including warranty work!!!
They will help you, and all will be well!

Good luck!
You will be fine now!

Thank You
Bless you,ngfam1
PS. Please give me a good rating here in before you sign out!

Aug 28, 2008 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Please help

it is the timer or, it may be a short of some kind

Apr 19, 2008 | GE WDSR2080D Top Load Washer

2 Answers

Front load Frigidaire Gallery washer

You are having a door switch problem change it out and you will have a new washing machine.

Dec 14, 2007 | Frigidaire GLTR1670A Front Load Washer

4 Answers

Frigidaire front load washer problems

My problem is that water is still draining when it goes to final spin. final spin is not working properly. then machine shuts itself off before timer.

Nov 16, 2007 | Frigidaire GLTR1670A Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

1,198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers


Level 3 Expert

77932 Answers

Brad Brown

Level 3 Expert

16802 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides