Question about Sony Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television

1 Answer

SONY LCD GOES OFF

When i switch on, it goes off after a few seconds and the red indicator flashes 4 times in intervals of two seconds,

Posted by on

  • KrisBrock Jun 04, 2008

    I have the same problem. Power light flashed green and then turns red. No picture!

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Try turning the tv off, then unplug the tv from the wall for at least 60secs. Plug it back in. Turn it on and see if the blinking has been reset to normal.

Posted on Jun 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Problem with Sony Grand Wega TV


This could be due to bad capacitors in the sweep supply, a bad High Voltage block, a bad regulator.

Jul 06, 2008 | Sony Grand WEGA KF50WE610 50" Rear...

1 Answer

Sony lcd projection tv in self diagnosis mode. 4 red flashes


This is a fan error take the back off the set and see if the fan is turning.

Sep 13, 2009 | Projection Televisions

1 Answer

Tv comes on and goes off in about 15 seconds. red


Brand, Model, is it an LCD, Plasma, or Projection TV?

May 11, 2009 | Sony Grand WEGA KDF-50WE655 50" Rear...

1 Answer

Sony 50 Wega LCD flashing red light


Hi

How many times is the red light flashing? The number of times the red led blinks means---


  • Continuous blink once a second, no pausing - No reply from the jungle IC301 (data bus is busy, shorted to ground, or held high), IK video path is defective.

  • One blink - not used for the self-diagnosis

  • Two blinks - B+ over current protection (OCP), unit goes to the standby mode then displays the 2 blink fault. Could be a short in the power supply of any of the circuits.

  • Three blinks - B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is also a problem in the power supply circuit, check T603 and R672.
  • Four blinks - No vertical Deflection (V STOP), Screen goes to a single horizontal line then the video signal muted. Check IC1509, Q1505

  • Five blinks - AKB circuit (automatic kine bias), the timer/standby indicator blinks for about 30 seconds then goes to the self-diagnosis function. Something is wrong with the video. Check video out, Q705, 732, 761 and other components on the C board, also check Q218, 219, 220 on the A board. In addition, unit could be in IK blanking, try turning up screen slightly.

  • Six blinks - No Horizontal (H STOP), no raster, goes to the blinking self-diagnosis function immediately. Check C515 & 516 and the jungle IC, IC206.

  • Seven blinks - High voltage shutdown. The high voltage has exceeded 33k and the unit goes immediately into safety shutdown. Check power supply regulation and horizontal circuits.

  • Eight blinks - Problem with the audio (AUDIO), unit goes to standby and blinks the self-diagnosis code. Check IC406 audio amp, PS401, and 402. On some projection models of Sony TV sets, this code means that T8005 (flyback transformer), or the associative components in the high voltage circuits are defective on the D board.


  • Nine blinks - Replace D 6116 and D 6301 on the "G" board, do not resolder as this will fix the problem temporary. Or Panel Module Error or Thermal Error. If it is intermittent 9 blinks, meaning sometimes the TV comes on and other times you get flashing, then change the switching regulator on the "G" board or check connections. Make sure the regulator is -12 or -13 (negitive).
  • Ten blinks - Check Q8014 and Q8013 for shorts, leakage, or bad solder connections on the " D" board. If the transistors are bad, check R8051 and IC8005, also on the "D" board.
  • No blinks(Unit is dead) - Problem in the standby power section. Might check fuse, R607, Q601, IC601, R612 and VDR601 (should show open).
Please do rate this solution as FixYa and revert for further assistance.

Thanks
Rylee

May 01, 2009 | Sony Grand WEGA KDF-50WE655 50" Rear...

1 Answer

TV won't come on. Standby goes green,then goes red blinks 3 times


3 flashes means the lamp door is not on correctly or the lamp door switch is broken.

Apr 08, 2009 | Sony Grand WEGA KF-50WE620 Television

1 Answer

Sony KDF-55WF655 Won't Pwr up


There's a fan in the optical block (light engine) You may also have either an intermittent fan or a bad connection from the fan(s)

michtech

Jan 28, 2009 | Sony Grand WEGA KDF-55WF655 36" Rear...

1 Answer

Standby indicator light on TV flashes - Sony TV


Hi,
    Please check fisrst that indicator liight (LED) blinks how many times.it could be from 1 to 8 times and the interval would be of three seconds.So, count the led flashes how many times and then tell me i will try my best to find and fix the solution.

Thanks 

Nov 17, 2008 | Sony KP-53HS30 53" Rear Projection...

1 Answer

Sony KP-FX43M31


On the Sony FX43 100Hz 43-inch rear projection TV, three flashes indicates an Over Voltage Protection problem, occurring in one of the power supply circuits T603 or R672.

The fix will most likely cost more than the set is worth second-hand, I'm afraid.

Jun 28, 2008 | Sony KP-51WS510 51" Rear Projection...

2 Answers

Won't come on


hy i got a toshiba 42" LCD tv ,when i press the power boton
iget the red light,& it stay that way ontil i pressthe power back off
thanks for any help

Jun 26, 2008 | Toshiba 62HM95 62" HDTV

Not finding what you are looking for?
Sony Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Projection Televisions Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Ap12
Ap12

Level 2 Expert

103 Answers

Jason Harris
Jason Harris

Level 2 Expert

256 Answers

Are you a Sony Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...