Question about Kaz Home Environment Replacement Ultraviolet Light Bulbs for Honeywell HFD-135 Air Purifier Air Purifier

1 Answer

Outside pole light with dusk to dawn sensor. Comes on at dark and then It goes off & on all night but shuts off in the morning? What is wrong with this thing?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

The light itself is likely bright enough to trip the photo cell back off. Rinse and repeat...

Posted on Jan 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power button won't shut it off...have to unplug it.


Dawn, a local vacuum shop can change defective switch for you.

Mar 27, 2016 | Panasonic MC-UL915 Upright Vacuum Cleaner

1 Answer

02 jetta battery goes down if sits more than 8 hours


You have a short in your system. It could be as simple as a light staying on somewhere in the car, ceiling, ashtray, rear reading lights, and the all time favorite the trunk light that tends to be the biggest culprit. Check in your cigarette lighter and charging ports, something may be in there causing this problem. When battery is charged and you shut off your car go around and check that all lights are out. When you open your trunk the light always comes on, but if you reach in and it's very hot (BE VERY CAREFUL HOT IF IT'S BEEN ON) . One bulb ON can kill the battery in a few hours. Also I forgot to ask did you have any work done to your car prior to this problem, there may be some pinched wires involved. GOOD LUCK FREIND.

Sep 29, 2014 | AM Auto Parts 2002 to 2005 VW Jetta Mass...

1 Answer

Fresh air 2, blue light goes out, fan still works, reads


If the light goes out, it is time to replace the bulb AND the bulb starter. They need to be replaced every two years. Beyond that, they are an expensive night light. If you need to order one, call (336) 499-2505. Also ask for supplemental cleaning instructions since the original instructions are incomplete.

Jun 10, 2012 | Ecoquest Fresh Air Air Purifier

1 Answer

I've replaced the filter. why won't the red replace filter light shut off?!


Remove the front cover and locate the FILTER RESET button above the dust sensor level indicator lights. Press and hold this button for 3 seconds until the unit emits a beep and the REPLACE FILTER light goes out.

Sep 03, 2010 | Winix PlasmaWave 5000 Air Purifier

2 Answers

Sharper Image Hybrid GP. Unit powers on, goes to


The solution drgoff provided ( the guy that used to work for Sharper Image ) actually did the trick !!!! Super excited to have this unit working again , thanks drgoff

Jul 07, 2009 | Sharper Image Hybrid GP (SI724) Air...

1 Answer

CENTRAL AIR UNIT IS NOT BLOWING INSIDE BUT THE COMPRESSOR OUTSIDE IS RUNNING. WHEN I GO DOWN TO THE BASEMENT TO CHECK THE FILTER-THE BOTTOM OF THE UNIT AND THE FILTER IS WATER LOGGED. ORIGINALLY IT WAS...


There may be a leak. You might try shutting it down and taking a look inside. On the other end, there may be something wrong with your components inside. The compressor outside is to provide coolant. Inside, the fans actually cool the air. Make sure all doors are on the blower downstairs, and if all else fails, call a technician. Good luck!

Jun 19, 2009 | Ecoquest Flair Air Purifier

1 Answer

Quadra will not turn on after cleaning


If, when you push the on button it sizzles for a sec and then shuts off (red clean light goes on), I have the same problem and haven't been able to fix it. However, others have had the same problem and have posted their solutions. The sizzling sound is caused by electrical arching between the plates and one or both of the two tungsten wires that are run parallel to the plates (if you turn off all the lights and wait for your eyes to adjust to the dark before turning on the Ionic Breeze, it's a pretty cool light show!) Here are things found by others to cause the arching and what they did to fix the problem:
  • --dirt, lint, or tiny hairs stuck somewhere (usually towards the top or bottom of the plates or wire, and maybe in the grid contact points). Clean it better. Using canned air can help blow out the problem.
  • --water droplets. Make certain there is no moisture anywhere when you put the grid (plates) back in. Using canned air can help dry hard to reach areas.
  • --burn marks or melted plastic. These indicates a short circuit. Says dnewcombe1: "There is a feeler bracket that guides the two rear thin wires while the cartridge is being inserted. This "feeler" can melt and become disarranged." You can't fix this issue.
  • --build up on the ionizing wires. Clean them. It's hard. I took mine apart and used steel wool.

Jun 07, 2009 | Sharper Image Ionic Breeze® Quadra® 4.0...

2 Answers

My sharper image air purifier cleaning light comes on


Can you clarify the problem.. all I can see is 

"My sharper image air purifier cleaning light comes... when it is clean"
The light that informs you that its in need of clearning comes on even though it is clean?

make sure the purifier is completely clean and reset it by unpluging it from the powersource for 30 minutes, the manual may include a reset process which might fix the problem.

Nov 28, 2008 | Sharper Image Professional Plus Ionic...

2 Answers

Ionic breeze gp keeps shutting off and clean light goes on


Oh there are a lot of known issues! I used to work for sharper image and I believed in this items very much so until mine broke. However after a year I figured out how to fix it. Take the big square collection grid out and the back screen off. Now get you a thick rag and be very careful because there are several tiny wires going up and down. Smaller than dental floss, you need to be very careful because you can either brake them or slice your finger wide open( Under any circumstances I can not be held liable for the information I am giving you try this at your own risk). Now with the towel very gently go up and down each wire like you are polishing a brass pole(once again these wires are thin and can break or cut you). Do this from the back side of the unit and from the inside where the collection grid that you took out sits. Take your time and be thorough, and presto your 400 dollar air cleaner is working again.

Nov 25, 2008 | Sharper Image Professional Plus Ionic...

Not finding what you are looking for?
Kaz Home Environment Replacement Ultraviolet Light Bulbs for Honeywell HFD-135 Air Purifier Air Purifier Logo

620 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kaz Air Purifiers Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Kaz Air Purifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...