Question about Music

1 Answer

Dear Anyone @ FIXYA , I need to get a slightly poorly Electro-harmonix super space drum back to match fitness . Currently its output is generally noisier than it should be and it can make some sounds of its own accord . The drum was part of an important 'album' and the Bands sound and they're going live again soon . Anybody any advice on where I might take it so it can be happy again ? Bazza ( )

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,138 Answers

You may or may not get some info from this link: This thread about the factory is old but may help: Just some suggestions.

Posted on Oct 13, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Name some best Distortion Pedal. Where to buy them?

The best top 5 distortion pedal are:-
  • BOSS Audio DS1 Distortion Guitar Pedal
  • Pro Co RAT2 Distortion Pedal
  • Boss BD-2 Blues Driver Guitar Effects Pedal
  • Electro-Harmonix Nano Big Guitar Distortion Effects Pedal
  • Electro-Harmonix Soul Food Distortion/Fuzz/Overdrive Pedal
I use to buy any distortion pedal from this site
Top 5 Best Distortion Pedal You Must Buy New 2017 Musical Study as they guide the best to buy the best.

Jan 02, 2017 | Music

1 Answer

Chorus on- no problem- noise free. Chorus off- big problem- massive hum. This item is supposedly "new" (stupid me, I bought from Ebay...)

It sounds like the bypass contacts on the pedal are not working... this may be right in the pedal switch itself. With unit in off position, use an ohmmeter to check continuity between in and out cable tips.

Sep 07, 2011 | Electro-Harmonix Electro Harmonix Neo...

1 Answer

I have a electro-harmonix , voice box , harmony machine and vocoder! I need to know what kind of power supply to use , as I have lost mine !

Takes a 9 volt DC 1 amp (1000 ma) center positive adapter. Not too common, search online and at Ebay.

Jul 28, 2011 | Music

1 Answer

A big hum of 100 c/s in the output,i need the schematic for repair

You must be on 50Hz power. You don't really need a schematic to repair the unit. Since the hum is twice power line frequency, the likely cause is the electrolytic filter cap for the high voltage has failed. The cap should be obvious in the unit. It will be near rectifier diodes and have a voltage rating above 50 volts. To test, bridge the one in there with another cap observing the correct polarity. If hum changes, replace the original cap.

May 25, 2011 | Electro-Harmonix 12ay7 Tube Microphone...

1 Answer

It stopped working and smelled burnt

I suspect the inut power circuits have a failure. Electrolytic filter cap and the votage regulator (probably a 7805 type) may have failed. IF the 7805 failed, then there is likely a short on the 5 volt supply to the electronics. In short, unless you are adept at electronics, you need to take it to an electronic tech for repair.

Nov 30, 2009 | Electro-Harmonix The Wiggler

1 Answer

Guitar pedal wiring

If you only replaced the jacks, then check where you soldered your wires. The ground wire from the circuit board an/or switch will be wired to the sleeve of the jack. The tip of the jack would be wired to the output lug of the switch. Also check the wiring on your in jack to make sure the correct wire is going directly to the switch from the jack's tip. The ground wire will go from the sleeve to the circuit board and/or ground lug on the switch.

Post your email and I can help you out if you do not fix it.

Aug 04, 2009 | Electro-Harmonix The Wiggler

Not finding what you are looking for?
Music Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Music Experts

Michial Gueffroy

Level 3 Expert

1138 Answers

Vito Vacirca Jr.

Level 2 Expert

140 Answers


Level 3 Expert

102366 Answers

Are you a Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides