When i start my computer it floppy casing open[40] press F1 to continue

Go into BIOS Setup, and disable the FDD

Regards,
joecoolvette

First thing, check to see if the is a floppy disk in the floppy drive, if so removes this disk. If there was no disk in the floppy drive then it may be a hard disk problem.
Check the BIOS to see if the hard disk is detected, if not open the case and re-seat the data cable on the hard drive and also where it connects to the motherboard disk controller.
If it still gives this error message and the BIOS does not detect this hard drive, then the hard drive is probably faulty.

To get the computer operating again, install a new hard drive in your computer and then install Windows on this hard drive plus the computer's device drivers and your programs.

Press f2 then Floppy disable please f10 press save
or BIOS problem reset bios

click F2 and then change the settings as yo like

The "floppy" disk-drive (3.5-inch diskette) on your computer is broken.
Press F1 to ignore the error, and to boot from your C: drive.
Or, press F2 to enter BIOS SETUP, and then navigate through those "setup" screens to tell the computer to "disable floppy seek", or change the setting from "3.5 1.44Mb drive" to "none".
Or, take the computer to a technician, and buy a replacement disk-drive, and get it installed.

This indicates that your computer is configured to boot on the floppy drive.
1. At the start of the computer Press F2
2. Go to the Boot Device Configuration.
3. Enable Hard Disk Boot Priority.
4. Set the First Boot Priority to Hard Disk
5. Save and Exit.

Please let me know of the outcome. Thank you and regards.

f1 is not bord problem. repair operating system. fdd( floppy drive) we can see hard drive/ optical drive/fdd in bios if we have not floppy drive in our computer we should do dodisable it in bios. i f we not do disable it in bios computer take along time in opening period it means bootin to serch floppy drive,

its looking for a floppy drive ..go to the bios and take the floppy drive out ..

Press F2 to enter the Bios, on the first screen navigate to the floppy A: drive select disable and the error should go away.

From the sounds of it your Floppy drive is damaged or just bad. you can take it for repair or purchase a new one fairly cheap and replace it yourself. But just disabling it should do the trick since floppy's are pretty much obsolete.

the recovery Disk wont help you unless its an error you get in windows itself btw.. (unless its a OS start problem which this doesn't seem to be)

Sounds like you have a bad/disconnected Hard Drive and the system is looking for a second boot device (ie: Floppy with a disk) or your primary IDE channel on your motherboard is bad