Question about Belkin PC Desktops

1 Answer

Internet led red on model f5d7633-4 - Belkin PC Desktops

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 31 Answers

Try to unplug the pwr cable and wait for 5 minutes and then plug in

Posted on Jun 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Motherboard User Manual For SiS965L?


SiS965L is a chipset designation, not a motherboard model number. That said, most motherboards do label the header pins for the front panel connections on the motherboard, though they are a bit small and sometimes are not adjacent to the pins themselves. The Power Switch and Reset Switch pins are not polarized, and when you determine which they are, the connector plug can be installed on them either way. The Power LED and HDD LEDs ARE polarized. The positive pin is marked with a "+" sign and the Green wore of the Power LED and the Red wire of the HDD LED must be on the "+" terminal.

Nov 09, 2015 | PC Desktops

1 Answer

Hard drive led light stays on after i turn off computer


have a look at p28 of the set up guide
http://downloads.dell.com/Manuals/Common/inspiron-560_setup%20guide_en-us.pdf
and read this for an idea also
Power LED stays on when computer shuts down
(I searched the internet on "Red led light in front of computer stays on after i turn off computer " to obtain many results, this is just one)
23.February.2015

Apr 29, 2014 | Dell Inspiron 560 PC Desktop

1 Answer

T6216


There should be 2 rows of pins in parallel usually around the bottom edge of the motherboard. The markings for which is which should be next to them on the board. HDled+, HdLed-, PwrSw, PwrLed, or something similar.

If you do find them but the hard drive Led does'nt come on it's because the plug for it needs to be turned around the opposite way, Led's only work one way as they are diodes. Same for the Power Led.

If there are no letters near the pins then you would have to find the motherboard manual.

Jan 28, 2012 | E-Machines eMachines Desktop PC

1 Answer

Computer shut down and red light flashing five times then three second pause and repeats


According to the troubleshooting guide for this model, the red light flashing five times indicates a problem in the RAM (memory), before the video subsystem is ready. You may just need to open the case and make sure the memory sticks are fully locked in their slots. If you just added new memory, it might not match the required specs.

Blank screen and the power LED flashes Red five times, once every second, followed by a two second pause, and the computer beeps five times. (Beeps stop after fifth iteration but LEDs continue flashing.)

Cause Pre-video memory error.

Solution
1.
Reseat DIMMs. Power on the system.

2. Replace DIMMs one at a time to isolate the faulty module.

3. Replace third-party memory with HP memory.
4. Replace the system board.

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01363877/c01363877.pdf

Jul 16, 2011 | HP Compaq DC5800 Small Form Factor PC...

4 Answers

Hp compaq dc 7100 , my problem is that as i start my pc than 4 beep with time interval 0.2 sec with led than after 0.5 sec it start again , remain continously


Are they Long Beeps? Does the RED led light on the front show up?
If there is no RED led light blinking, then the problem is your RAM.
If there IS a RED led Light showing up, then the problem is your Power Supply.

Mar 27, 2011 | HP Compaq dc7100 PC Desktop

2 Answers

Pulled off front cover. three sets of wires came off. need to know where to reconnect. white/red wire HDD LED, white/green wire POWER LED, white/black wire POWER SW


Hi. You may want to check your motherboard for this wires to connect to, First, check your motherboards manual and look where the FRONT PANEL is located, then on the front panel or in the manual itself it will tell you where are those wires should be connected to. If you dont have the manual for your motherboard search it on google and do the same, and if still you coudnt find it over the internet then just look closely on your motherboard and look for the words HDD LED, POWER LED and POWER SW, usually those words or the FRONT PANEL is located on the left side bottom part of your motherboard. Hope This Helps

Jun 09, 2010 | E-Machines T3302 PC Desktop

1 Answer

The lights of the internal modem, which used to be green, now just keep red/orange.... therefore no more internet... could it be a virus?


Good day sir/maam, the orange led indicates a speed of 10 mbps, which means that either the internet becomes slow or your connected to a hub with 10 mbps. better swap a new modem card, anyway its cheap. or get a DSL.hope this helps.

Oct 06, 2009 | Dell Dimension 9100 PC Desktop

1 Answer

Power light on& status light on


The power red led indicates that your device is "power on" , but the status led still red and turn to green if the device ( video input )received video signal ( from DVD player, Laptop etc. ) .

Apr 29, 2009 | PC Desktops

1 Answer

Proper connection


if u look real close to the pins on the board they will say pwd led and power sw ect ect please keep me posted if you need more help identifying these pins

Aug 06, 2008 | E-Machines eMachines Desktop PC

Not finding what you are looking for?
PC Desktops Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Belkin PC Desktops Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

Gareth Cockram
Gareth Cockram

Level 3 Expert

657 Answers

Douglas  Erikson
Douglas Erikson

Level 2 Expert

62 Answers

Are you a Belkin PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...